The system analysis of the MIMO optimal feedback quantization used to produce switching signals is proposed here. The switching signals are then fed into the switch mode power amplifier to drive actuator array. The architecture of the power amplifier used in this paper allows the sharing of switching elements among actuators and is different from the traditional one-to-one method in actuating a...

Class-E amplifiers are a type of switching amplifier offering very high efficiency approaching 100% . In this paper, a topology and design methodology, which could be used for a transmission-line implementation of a class-E power amplifier, is presented. A simple transmission-line class-E load network is proposed that offers combined transformation of the load resistance down to a suitable leve...

High-power high-voltage dc power supply has been developed based on series resonant converter technology for a MW class RF amplifier. For low-voltage ripple, an IGBT inverter consisting of 1400 V-600 A devices is drives with a maximum switching frequency of 31.2 kHz. A performance test was carried out using an RF amplifier. We examined this power supply under two different conditions. One was w...

A digital look-up table adaptive predistortion technique using a six-port receiver for power amplifier linearization is presented. The system is designed in Ka-band for a DVB-S2 satellite link. We use a six-port receiver at the linearizationloop in place of classic heterodyne receivers. The six-port receiver is implemented by the use of passive microwavecircuits and detector diodes. This approa...

This article proposes a new method for application in communication circuit systems that increase efficiency, PAE, output power and gain in the circuit. The proposed method is based on a combination of switching class-E and class-J and has been termed class-EJ. This method was investigated using both theory and simulation to confirm ∼72% PAE and output power of >39dBm. The combination and desig...

This work deals with power optimization of the audio processing back end for hearing aids the interpolation filter (IF), the sigma-delta ( modulator and the Class D power amplifier (PA) as a whole. Specifications are derived and insight into the tradeoffs involved is used to optimize the interpolation filter and the  modulator on the system level so that the switching frequency of the Clas...

The hybrid amplifier that combines a buck converter and linear has been widely used as the envelope tracking (ET) supply modulator for ET power (PA) application. Instead of adding more large off-chip passives to raise efficiency amplifier, this work uses Viterbi-like trellis search (TS) digital signal processing (DSP) algorithm find optimal switching sequence in lowering RMS error current op-am...

This paper provides the design approach of one stage switching-mode based class F power amplifier (PA).The device’s nonlinear behavior was analyzed to reduce the dissipated power over the active device and therefore the PA efficiency was increase without having to compromise the power amplifier’s size. The load harmonics were controlled so that the drain voltage and the drain current do rarely ...

a novel low noise trans-impedance amplifier is proposed using low cost 0.18 µm cmos technology. a resistive-capacitive feedback is used to extend the bandwidth of the amplifier. as the structure is inductor less, it is suitable for low cost integrated optical interconnects. in this paper improved particle swarm optimization have applied to determine optimal trans-resistance and noise of propose...