A three-dimensional (3D) representative volume element (RVE) model was developed for analyzing effective mechanical behavior of fiber-reinforced ceramic matrix composites with imperfect interfaces. In the model, the fiber is assumed to be perfectly elastic until its tensile strength, and the ceramic material is modeled by an elasto-plastic Drucker-Prager constitutive law. The RVE model is then ...

The effects of zein ratio, concentration of glycerol, liquid-solid ratio, ethanol concentration, pH and heat-treatment temperature on the properties of zein/wheat gluten composite films were researched. The results showed that elongation (E) increased with an increase in glycerol or ethanol concentrations, but it first increased and then decreased with increasing zein/wheat gluten ratio, heat-t...

The transfer of surface-generated meltwater to the subglacial drainage system through full ice thickness crevassing may lead to accelerated glacier velocities, with implications for ice motion under future climatic scenarios. Accurate predictions of where surface meltwater accesses the ice/bed interface are therefore needed in fully coupled hydrodynamic ice-sheet models. We present a spatially ...

High-entropy alloys (HEAs) can have either high strength or high ductility, and a simultaneous achievement of both still constitutes a tough challenge. The inferior castability and compositional segregation of HEAs are also obstacles for their technological applications. To tackle these problems, here we proposed a novel strategy to design HEAs using the eutectic alloy concept, i.e. to achieve ...

A Fe-20.1Mn-1.23Si-1.72Al-0.5C TWIP steel with ultra-fine grain structure was successfully processed through Equal Channel Angular Pressing (ECAP) at warm temperature up to four passes following the BC route. The microstructure evolution was characterized by Electron Back Scattered Diffraction (EBSD) to obtain the grain maps, which revealed an obvious reduction of grain size, as well as a decre...

[Purpose] The aim of this study was to verify how the application of elastic tape to the anterior surface of the thigh changes the knee angle pattern during gait. [Subjects] The subjects were 10 people who showed an abnormal knee angle change pattern during usual walking. They did not show the so-called double knee action. [Methods] Subjects were asked to walk as usual, and then to walk with el...

The internal pressure strength of tubing and casing often cannot satisfy the design requirements in high pressure, high temperature and high H2S gas wells. Also, the practical safety coefficient of some wells is lower than the design standard according to the current API 5C3 standard, which brings some perplexity to the design. The ISO 10400: 2007 provides the model which can calculate the burs...

In this paper, we describe an experimental study of concrete behavior under a uniaxial tensile load by use of the thermally-compensated Coda Wave Interferometry (CWI) analysis. Under laboratory conditions, uniaxial tensile load cycles are imposed on a cylindrical concrete specimen, with continuous ultrasonic measurements being recorded within the scope of bias control protocols. A thermally-com...

BACKGROUND Finite element simulation has been used in last years for analysing the biomechanical performance of post-core restorations in endodontics, but results of these simulations have been interpreted in most of the works using von Mises stress criterion. However, the validity of this failure criterion for brittle materials, which are present in these restorations, is questionable. The obj...

Ultrafine-grained (UFG) pure copper of 280 nm grain size was prepared by equal-channel angular pressing. Tensile tests, strain-rate change tests and temperature change tests were conducted on UFG Cu in the temperature range between 77K and 373K. As usual, tensile strength increased as temperature decreased and strain rate increased. The activation energy of deformation increased linearly with t...