in this paper, an intelligent control strategy based on combination of the “flatness based control technique” and the “perturbation and observation (p&o;) mppt algorithm” is developed and investigated to control a hybrid electric energy source (heps). this ehps is composed of a fuel cell system (fc) and a solar panel (sp), as the main source and a supercapacitor bank (sc), as the auxiliary sour...

This paper presents Growing Neural Gas (GNG) based a maximum power point tracking (MPPT) technique for a high performance wind generator using DFIG. It is used in variable speed wind energy conversion system. Here, two back to back converters is used and connected to the stator, correspondingly FOC and VOC is done on machine and supply side converter. Constant voltage over the grid is obtained ...

This paper presents the comparative analysis between constant duty cycle and Perturb & Observe (P&O) algorithm for extracting the power from Photovoltaic Array (PVA). Because of nonlinear characteristics of PV cell, the maximum power can be extract under particular voltage condition. Therefore, Maximum Power Point Tracking (MPPT) algorithms are used in PVA to maximize the output power. In this ...

This paper presents the development of a high gain Boost converter applied to photovoltaic (PV) system. The converter was designed to be connected directly to the photovoltaic panel and perform the search for the maximum power point (MPPT). The new proposal seeks the MPPT is to connect each panel a converter for a high gain greater accuracy in finding the point of maximum power. The converter w...

To maximise the economic benefit, photovoltaic (PV) systems in general operate in the so-called maximum power point tracking (MPPT) mode. However, in certain occasions (e.g. in a microgrid or in a weak system), it is beneficial for a PV system not to always operate in the MPPT mode, but occasionally in the power dispatch mode, because of the top priority of maintaining system stability. To this...

The implementation of maximum power point tracking (MPPT) schemes by the ripple correlation control (RCC) algorithm is presented in this paper. A reference is made to single-phase single-stage multilevel photovoltaic (PV) generation systems, when the inverter input variables (PV voltage and PV current) have multiple low-frequency (ripple) harmonics. The harmonic analysis is carried out with ref...

This experimental study deals with the investigation of chaos during the regulation of output voltage of solar photovoltaic module. The Cuk converter is used as an interface between solar PV module and load, since the Cuk converter is the good choice for the maximum power point tracking (MPPT) circuits. The input voltage of the converter is controlled in order to regulate the operating point of...

---------------------------------------------------------------------***--------------------------------------------------------------------Abstract –This paper proposes the controlling of the photovoltaic (PV) system by sliding mode control(SMC). Here, open circuit voltage MPPT technique is used to track maximum power point. There is a difficulty in tracking the maximum power point of the phot...

Abstract—This paper presents a grid synchronization technique based on adaptive notch filter for SPV (Solar Photovoltaic) system along with MPPT (Maximum Power Point Tracking) techniques. An efficient grid synchronization technique offers proficient detection of various components of grid signal like phase and frequency. It also acts as a barrier for harmonics and other disturbances in grid sig...

this paper presents a grid connected photovoltaic system, which acts as both power generator and active power filter (apf), based on flying capacitor multicell (fcm) converter. increase in the number of output voltage levels, natural self-balancing of flying capacitors and dc link voltage and lower power rating of components are the main futures of fcm converter compared with conventional multi...