in this work, zno/sio2 nanoparticles were prepared using sol-gel method, and platinum particles were loaded on zno/sio2 nanoparticles by photoreductive method. samples were characterized by x-ray diffraction (xrd), scanning electron microscopy (sem) and fourier transform infrared spectroscopy (ft-ir). the xrd patterns showed that the zinc oxide samples have a wurtzite structure (hexagonal phase...

The synthesis of ZnO nanoparticles has attracted immense interest because of their unique properties and potential applications in optoelectronic devices. ZnO as a wide band gap semiconductor with large excitation energy becomes one of the most important functional material with near UV-emission, optical transparency, electric conductivity and piezoelectricity. ZnO nanoparticles were prepared b...

As bimodal magnetic-fluorescent imaging agents, the preparation of ZnS:Tb,Gd and ZnS:Er,Yb,Gd nanoparticles via a facile homogeneous precipitation method is reported. The results show that these nanoparticles are almost spherical in shape with a diameter of 100-200 nm approximately and a major phase of wurtzite-structured ZnS. The products can successfully label the human hepatocellular carcino...

Thin films of Cu2ZnSnS4 (CZTS) were synthesized via a low cost, wet chemical technique of chemical bath deposition (CBD). In the first part of this study, the chemical composition ratio S/(Cu+Zn+Sn) was varied keeping Cu/(Zn + Sn) and Zn/Sn ratios constant to study the effect of sulfur variation. Detailed electrical and optical characterization has been carried out using UV-Vis spectroscopy, x-...

A non-destructive Raman spectroscopy has been widely used as a complimentary method to X-ray diffraction characterization of Cu2ZnSnS4 (CZTS) thin films, yet our knowledge of the Raman active fundamental modes in this material is far from complete. Focusing on polarized Raman spectroscopy provides important information about the relationship between Raman modes and CZTS crystal structure. In th...

Low cost single stoichiometric target sputtering of Cu2ZnSnS4 (CZTS) precursor has been adopted to fabricate CZTS solar cells. The effect of a series of deposition pressures and deposition durations on the device performance has been investigated. A 3.74% efficient solar cell has been achieved at a base pressure of 1 × 10−4 Torr with a stoichiometric target, which to the authors’ knowledge, is ...

Joglekar, Chinmay S. M.S.Ch.E., Purdue University, May 2014. CZTSSe Thin Film Solar Cells: Surface Treatments. Major Professor: Rakesh Agrawal. Chalcopyrite semiconducting materials, specifically CZTS, are a promising alternative to traditional silicon solar cell technology. Because of the high absorption coefficient; films of the order of 1 μm thickness are sufficient for the fabrication of so...

The size-dependent structure of CdSe nanoparticles, with diameters ranging from 2 to 4 nm, has been studied using the atomic pair distribution function PDF method. The core structure of the measured CdSe nanoparticles can be described in terms of the wurtzite atomic structure with extensive stacking faults. The density of faults in the nanoparticles is 50%. The diameter of the core region was e...

Several important synthetic parameters such as precursor concentration, rate of evaporation and reaction time are found to determine the growth of ZnO nanostructures. These reaction parameters can be tailored and tuned to produce a variety of nanostructures ranging from nanoparticles, nanorods and nanospheres. The nanorods are structurally uniform made up of crystallographically oriented attach...

This paper described the optical properties of CdSe and CdSe/CdS nanoparticles, synthesized by the microemulsion method followed by refluxing in toluene/methanol (60:1). Both optical spectroscopy and structural characterization (XPS, XRD, and HRTEM) suggested the core/shell structure of CdSe/CdS samples. Most notable in this work was that capping CdSe nanoparticles with CdS materials yielded a ...