Abstract. The potential of improving the mechanical strength by RCS process is evaluated on 5754, 6061, and 7075 aluminum alloys, which present different hardening mechanisms related to their respective alloying elements. This work compares evolution texture properties alloys through processing. were micro-hardness measurements, tensile tests at temperatures, strain rates evaluate strain-rate s...

This paper presents an explanation related to experimental testing in the form of tensile properties Al 6061. 6061 was heat treated by precipitation hardening method. The consisted T4 and T6 treatment. samples were heat-treated at a temperature 430°C for 2 hours, then cooled slowly room temperature. conducted 530°C followed rapid cooling water medium natural ageing 70°C six days. Temperature is...

The goal of the present research is to develop a better understanding of the tensile response of open-cellular aluminum 6061 T6 alloy. Both tensile and compression samples of this metallic foam were tested under constant strain rate conditions at 293, 423, and 523 K. Scanning electron microscopy was performed on individual struts to assess the modes and mechanisms associated with fracture. Theo...

Composites based on two aluminium alloys (A536 and 6061) reinforced with 10% or 20% volume fraction of SiC particles were produced by gravity casting and a novel two-step mixing method was applied successfully to improve the wettability and distribution of the particles. The SiC particles were observed to be located predominantly in the interdendrit ic regions, and a thermal lag model is propos...

High-speed machining is considered to be a promising technique due its advantages, such as high productivity and better product quality. With paradigm shift towards sustainable practices, the energy consumption analysis of high-speed also gaining ever-increasing importance. The current article addresses this issue presents detailed specific cutting (SCE) surface finish (Ra) during conventional ...

Joining of the similar & dissimilar materials alloys using heat friction in currently being used, especially for non-ferrous which are considered as non-weldable alloys. Al 2024-T6 6061-T6 having length 70mm and 12mm diameter were welded by welding process. Similar samples obtained applying different combinations parameters like pressure 30bar, forging from 50 to 60 bar, rotational speed 22...

12.7-mm thick plates of 6061-T6511 aluminum alloy and high hardness steel (528 HV) were successfully joined by a friction stir bonding process using a tungsten Process parameter variation experiments, which geometry, plunge and traverse rates, tool offset, spindle tilt, and rotation speed, were conducted to develop a parameter set which yielded a defect free joint. Laboratory tensile tests exhi...

This paper presents the design of a fiber-coupled self-mixing laser diode (SMLD) for non-contact and non-destructive measurement of Young's modulus. By the presented measuring system, the Young's modulus of aluminum 6061 and brass are measured as 70.0 GPa and 116.7 GPa, respectively, showing a good agreement within the standards in the literature and yielding a much smaller deviation and a high...