The removal of CO2 through chemical absorption in a bench-scale spray dryer absorber was investigated experimentally using the lime slurry as absorbent. The effect of important operating parameters on CO2 removal efficiency has been investigated; in selected ranges of operating parameters, increasing gas inlet temperature and absorbent concentration lead to permanent efficiency decline, increas...

performance optimization of a single-effect lithium bromide water absorption refrigerationsystem is the subject of this paper. first, the thermodynamic model of the system wasderived based on thefirst and second law analysis of an absorption refrigeration cycle with libr-water as the working fluid pair.then, the effects of different design parameters such as the generator inlet hot water temper...

A broadband Circuit Analogue (CA) absorber using double-circular-loop array is investigated in this paper. A simple equivalent circuit model is presented to accurately analyze this CA absorber. The circuit simulation of the proposed model agrees well with full-wave simulations. Optimization based the equivalent circuit model, is applied to design a single-layer circuit analogue absorber using d...

Recent developments in the following areas are briefly reviewed: a) the electrical structure of grain boundaries in CdTe absorbers, b) impurities and non-stoichiometry in CdTe solar cells and c) use of Sb2Te3 in contacts to CdTe. Nominally identical solar cells fabricated using 99.999% pure CdTe feedstock from two different suppliers were compared. Differences in the photovoltaic response and a...

Highly sensitive and fast photodetectors can enable low power, high bandwidth on-chip optical interconnects for silicon integrated electronics. III-V compound semiconductor direct-bandgap materials with high absorption coefficients are particularly promising for photodetection in energy-efficient optical links because of the potential to scale down the absorber size, and the resulting capacitan...

We report the design and performance of 300-mK composite bolometers that use micromesh absorbers and support structures patterned from thin films of low-stress silicon nitride. The small geometrical filling factor of the micromesh absorber provides 20x reduction in heat capacity and cosmic ray cross section relative to a solid absorber with no loss in IR-absorption efficiency. The support struc...

We fabricate a saturable absorber mirror by coating a graphene- film on an output coupler mirror. This is then used to obtain Q-switched mode-locking from a diode-pumped linear cavity channel waveguide laser inscribed in Ytterbium-doped Bismuthate Glass. The laser produces 1.06 ps pulses at ~1039 nm, with a 1.5 GHz repetition rate, 48% slope efficiency and 202 mW average output power. This perf...

A perfect ultra-narrow band infrared metamaterial absorber based on the all-metal-grating structure is proposed. The absorber presents a perfect absorption efficiency of over 98% with an ultra-narrow bandwidth of 0.66 nm at normal incidence. This high efficient absorption is contributed to the surface plasmon resonance. Moreover, the surface plasmon resonance-induced strong surface electric fie...

We report on heterojunction solar cells whose thin intrinsic crystalline absorber layer has been obtained by plasma enhanced chemical vapor deposition at 165°C on highly doped p-type (100) crystalline silicon substrates. We have studied the effect of the epitaxial intrinsic layer thickness in the range from 1 to 2.4 μm. This absorber is responsible for photo-generated current whereas highly dop...