A thermodynamic approach is presented to classify geothermal reservoir as vapor or liquid dominated. According to it, the vapor dominated reservoir has specific volume of fluid (i.e. combined vapor and liquid) greater than the critical volume of water whereas the liquid dominated reservoir has lesser specific volume. Enthalpy is not a conservative entity in a geothermal system. Apart from it, t...

To quantify the relative importance of the spleen in the carotid sinus baroreceptor reflex control of total blood volume, we studied the reflex control of systemic vascular capacity before and after removal of the spleen in 18 sodium pentobarbital-anesthetized dogs. Venous return was diverted into a reservoir while cardiac output and venous pressure were maintained constant. Intrasinus pressure...

Elemental sulfur (S8) is often present in considerable amounts in sour gas reservoirs at the reservoir conditions (pressure and temperature). For the isothermal conditions in the reservoir, the reduction in reservoir pressure below a critical value will cause the elemental sulfur to deposit in the formation. Sulfur deposition can cause severe loss in the pore space available for gas, and in tur...

Abstract Steam-water capillary pressure is often either ignored or determined artificially in geothermal reservoir engineering. However steam-water capillary pressure plays an important role in geothermal reservoir performance and may not be substituted by air-water capillary pressure. To this end, preliminary mathematical models have been developed to calculate drainage and imbibition steam-wa...

rock selection in modeling and simulation studies is usually based on two techniques; routinely defined rock types and those defined by special core analysis (scal). the challenge in utilizing these two techniques is that they are frequently assumed to be the same, but in practice, static rock-types (routinely defined) are not always representative of dynamic rock-types (scal defined) in the re...

withdrawal of oil and gas from reservoirs causes a decrease in pore pressure and an increase in effective stress which results to a reservoir compaction. reservoir compaction will result in surface subsidence through the elastic response of the subsurface. usually in order to determine the subsidence above a hydrocarbon field, the reservoir compaction must be first calculated and then the effec...

in this research, a new mathematical modeling on strength changes due to reservoir elastic stresses across the preexisting fault plane is introduced. the method has been applied to the dalpari fault, which is one of the potential seismic sources in the vicinity of the karkheh reservoir. in this method the distribution of total stress across the fault cannot be determined because the initial str...

The conventional determination of pulmonary vascular resistance does not indicate which vascular segments contribute to the total resistance of the pulmonary circulation. Using measurements of pressure and flow, the reservoir-wave model can be used to partition total pulmonary vascular resistance into arterial, microcirculation, and venous components. Changes to these resistance components are ...

Rock selection in modeling and simulation studies is usually based on two techniques; routinely defined rock types and those defined by special core analysis (SCAL). The challenge in utilizing these two techniques is that they are frequently assumed to be the same, but in practice, static rock-types (routinely defined) are not always representative of dynamic rock-types (SCAL defined) in the re...

thermo-elasto-plastic analyses of thick-walled spherical tanks made of functionally graded materials are investigated analytically. these tanks are subjected to positive or negative temperature gradient and internal pressure loadings separately or simultaneously. the power law modeling has been used for through-the-thickness variation of mechanical properties. von mises yield criterion and elas...