Optimal capacitor allocation in distribution systems has been studied for a long times. It is an optimization problem which has an objective to define the optimal sizes and locations of capacitors to be installed. In this works, an overview of capacitor placement problem in distribution systems is briefly introduced. The objective functions and constraints of the problem are listed and the meth...

The paper presents a high performance flying capacitor fed induction motor drive. To improve the performance of Flying Capacitor Multilevel Inverter (FCMLI) implement the switching pattern selection scheme. This scheme reduces capacitor voltage fluctuation without using voltage feedback. This method is developed for sinusoidal voltage generation using the sinusoidal pulse width modulation techn...

Version 2c, 3 October 2004 It is well known that dielectric absorption plays a critical role in determining the accuracy of analog sampled-data systems that are based on charge storage, such as sampleand-holds and switched-capacitor ADCs. Less appreciated, but no less important, is the role it plays in determining the quality factor, or Q, of the capacitor. Dielectric absorption has both storag...

─ the paper describes the operational principle of flying capacitor and modular multilevel inverters. The detailed discussions of dc link capacitors voltage balancing methods for both inverters are given in order to enable fair comparison. The causes of dc link capacitors voltage imbalance in flying capacitor multilevel inverter with more than three levels are highlighted. Computer simulation i...

optimal capacitor placement, considering power system loss reduction, voltage profile improvement, line reactive power decrease and power factor correction, is of particular importance in power system planning and control. the distribution system operator calculates the optimal place, number and capacity of capacitors based on two major purposes: active power loss reduction and return on invest...

A simple but accurate pseudo-passive mismatch-shaping D/A converter is described. A digital state machine is used to control the switching sequence of a symmetric two-capacitor network that performs the D/A conversion. The error caused by capacitor mismatch is uncorrelated with the input signal and has only little power in the signal band. The system has been simulated assuming a 0.1% capacitor...

-Multilayer ceramic chip capacitor CDR-05 (MIL part number) is one of the most used parts in ISRO’s satellite program. Cracks evolved in ceramic chip capacitors CDR-05 (size: 1825and dielectric: X7R) of two different makesduring soldering process are studied in this paper. It has been observed that CDR-05 capacitors of one particular make (Manufacturer-A) more prone to crack during soldering on...

Installation of capacitors in distribution networks is one of the most used procedure to compensate reactive power generated by loads and, consequently, to reduce technical losses. So, the problem consists in identifying the optimal placement and sizing of capacitors. This problem is known in the literature as optimal capacitor placement problem. Neverthless, depending on the location and size ...

The parallel-plate capacitor equation is widely used in contemporary material research for nanoscale applications and nanoelectronics. To apply this equation, flat and smooth electrodes are assumed for a capacitor. This essential assumption is often violated for thin-film capacitors because the formation of nanoscale roughness at the electrode interface is very probable for thin films grown via...

this paper describes an advantageous method for using the capacitor banks in the distribution network, optimally. the aim is to determine the count, location and capacitor values in order to minimize the annual cost resulting from energy losses and capacitor bank’s installation cost. besides, in the case of having nonlinear loads in the network, by installing capacitors in appropriate locations...