Casting solidification brings to the shrinkage in the liquid state, solidification shrinkage and shrinkage in the solid state. Recently, technologies of die and gravity casting have increased the number of highly functional castings, which have been characterized with the very complex geometry. due to the different wall thickness in these castings, as well as the high solidification rates, prem...

Given the requirements of a product, selecting the most suitable casting process is a multi-criteria decisionmaking problem. A number of casting processes are available today, and these differ greatly in terms of capabilities, advantages and limitations in relation to design (example: geometry), quality (ex. tolerance), production (ex. lead time) and cost (ex. labor). These characteristics vary...

Abstract: structures in alloys. This method is based on pouring the melt through a small sized nozzle into a mould located at acertain height under the crucible. This simple method generates globular structures without using equipments such asimpellers, electromagnetic stirrers, ultrasonic probes and cooling slopes. Therefore it is cost effective. In the presentstudy, the effect of casting size...

The type of lightweight aggregate and its volume fraction in a mix determine the density of lightweight concrete. Minimizing the density obviously requires a higher volume fraction, but this usually causes aggregates segregation in a conventional mixing process. This paper proposes a two-stage casting process to produce a lightweight concrete. This process involves placing lightweight aggregate...

The main objective of this research is to investigate the effect of dewaxing and burnout temperature on the quality of copper alloy casting produced by a low cost block mold that has been developed. In the molding process, two types of silica sand which contains 97.9% silica (SiO2) and 97.2% silica have been used as a refractory material with POP served as a binder. Several mold formulations co...

In the paper the analysis of wax pattern and casting dimensions changes during each stages of investment casting technology process has been presented. Results of wax patterns and castings of test plate free and restrained contractions dimensions changes research carried out in Department of Foundry Engineering at Brno University of Technology have been presented as well. Moreover obtained resu...

The effect of squeeze casting process parameters on wear behavior of AC2A aluminium alloy was primarily investigated in this experimental study. Five process parameters, namely squeeze pressure, pouring temperature, die temperature, die material and compression time, each at four levels were chosen and sixteen experimental runs based on L16 orthogonal array were performed. From analysis of vari...