Improving the efficiency of compressors has been one of the most important goals of researchers over the years. In this paper, three different methods are presented for parameterization and blade optimization of axial flow compressor. All methods consist of flow analysis tool, optimization algorithms, and parametric geometry generation tool, that are different in each approach. Objective functi...

Preview wind speed measurements from a forward looking Light Detection and Ranging (LIDAR) system located in the hub of a wind turbine can be used by a feedforward blade pitch control system to mitigate structural loads. For individual blade pitch control, a separate preview estimate of the effective wind speed encountered by each blade must be available. One way of providing an estimate of the...

This paper reviews the design optimization of wind turbine blades through investigating the design methods and analyzing the performance of the blades. The current research work in this area include wind turbine blade geometric design and optimization, aerodynamics analysis, wind turbine blade structural design and dynamics analysis. Blade geometric design addresses the design parameters, inclu...

Introductions to Philosophy There are many good introductions to philosophy: [21], [51] and [1] have the advantage of being short and cheap. There are a few books [42, 10, 33] that introduce philosophical ideas by analysing films which raise philosophical issues. One of the advantages of these books is that they allow you to say that you are doing valuable research for this module while watchin...

In above rated conditions, wind turbines are often subjected to undesirable high structural loading. We investigate two feedback control techniques in combination with a feedforward control method for reducing blade flap bending loads in above rated wind conditions. The feedback controls studied include both disturbance accommodating/tracking and integral augmented/repetitive types that incorpo...

A morphing segmented concept is proposed herein for future extreme-scale wind turbine systems. The morphing may be accomplished by using segmented blades connected by screw sockets and a tension cable system. At low wind and rotor speeds, the segmented blades are fully tensioned and set at high pitch to ensure start-up and maximum power at low speeds. At high rotor rpm, the cable tension can be...

introduction: epulis fissuratum is often formed as a result of a poor fitting denture. the conventional treatment for this fibrous hyperplastic tissue is to excise it using a scalpel and to close the wound by a continuous or an interrupted suture. the increased utilization of lasers in dentistry also includes the utilization of carbon dioxide (co2) lasers in place of surgical scalpels in soft t...

The performance of a waterfall-type cross-flow hydraulic turbine was investigated via experiment and numerical simulation. carried out using operating in two-dimensional waterfall, the result compared with corresponding analyzed by volume fluid method. experimental results show that maximum efficiency reached approximately 60%, higher than previous experiments literature. It also confirmed reco...

Accuracy is the key issue in the precision forging. Geometric and dimension errors are the two significant defects found in most of near net or net shape manufacturing process. It becomes more critical for complex part such as an AUV propeller blade. In this study, geometric error was quantified by comparing the blade profile obtained from nominal geometry of the blade and the profile construct...