Ductile cutting are most widely used in fabricating high-quality optical glass components to achieve crack-free surfaces. For ultra-precision machining of brittle glass materials, critical undeformed chip thickness (CUCT) commonly plays a pivotal role in determining the transition point from ductile cutting to brittle cutting. In this research, cutting characteristics in nanometric cutting of B...

The mechanism of cutting process of roadheader with cutting head was researched, and the influences of properties of coal and rock on cutting load were deeply analyzed. Aimed at the defects of traditional calculation method of cutting load on fully expressing the complex cutting process of cutting head, the method of finite element simulation was proposed to simulate the dynamic cutting process...

The dynamics of the cutting process are investigated. Using the increase of cutting depth as a control parameter, two diierent cutting regimes are observed. In the rst regime, which is observed at small cutting depths, complex, high-dimensional dynamics occur. In the second cutting regime, observed for deeper cuts, low dimensional dynamics are typical. The second cutting regime is usually ident...

* Corresponding author. E-mail address: [email protected] (T.E. Gr http://dx.doi.org/10.1016/j.biosystemseng.201 1537-5110/© 2015 IAgrE. Published by Elsevie Energycane is a promising bioenergy crop for warm south-eastern US regions and existing sugarcane machinery is being adapted for energycane cultivation. Because of energycane's comparatively higher fibre content and smaller stem diameters...

In this note we argue that semantic cutting planes refutations are stronger than syntactic ones. In particular, we give a formula for which any refutation in syntactic cutting planes requires exponential length, while there is a polynomial length refutation in semantic cutting planes. This means that syntactic cutting planes does not p-simulate (nor simulate) semantic cutting planes. We also gi...

A judicious choice of insert material, tool geometry and cutting conditions can make hard turning produce better surfaces than grinding. In the present study, an attempt has been made to investigate the effect of cutting tool materials on cutting forces (feed force, thrust force and cutting force) in finish hard turning of AISI D2 cold work tool steel. In conclusion of the results obtained with...

Nanometric cutting involves materials removal and deformation evolution in the surface at nanometer scale. At this length scale, atomistic simulation is a very useful tool to study the cutting process. In this study, large-scale molecular dynamics (MD) simulations with the model size up to 10 millions atoms have been performed to study three-dimensional nanometric cutting of copper. The EAM pot...

Vermicular graphite cast iron, which is widely used in the automotive industry because of outstanding strenght properties. But, there are many problem with regard to machinability of this material. In this study, optimum cutting parameters were studied in order to improve machinability of vermicular graphite cast iron. Experiment parameters which is appropriate for ISO 3685 was selected. Depend...

The development of chip morphology, critical cutting conditions of serrated chip formation and cutting forces were observed and measured by high speed machining experiment for 30CrNi3MoV hardened steel. Results show that the cutting speed and rake angle are leading factors to influence chip morphology and cutting forces. With the increase of cutting speed, the continuous band chip transforms in...