Rock at depth is subjected to stresses resulting from the weight of the overlying strata and from locked in stresses of tectonic origin. When an opening is excavated in this rock, the stress field is locally disrupted and a new set of stresses are induced in the rock surrounding the opening. Knowledge of the magnitudes and directions of these in situ and induced stresses is an essential compone...

Two distinct drying methods (spouted bed and spray drying) were used for production of dried extracts of Bauhinia forficata Link (Leguminosae, Caesalpinoideae). High-quality powder products in terms of physical and chemical properties were obtained. HPLC fingerprints revealed that the chromatographic profiles of flavonoid compounds present in the dried extract did not change significantly, due ...

Stability of underground structures is assessed by comparing rock strength with induced stresses resulted from ground stresses. Rock mass surrounding the opening may fail either by fracture or excessive deformation caused. Accurate calculation of induced stresses is therefore fundamental in the stability analysis of an opening. Although numerical methods, particularly finite element method, are...

Capillary suspensions, solid-liquid-liquid systems, are conventionally formulated by dispersing the particles in bulk phase and then adding a small amount of secondary liquid (<5 vol%), leading to increased yield stress. Previous work has shown that partially miscible liquids form capillary bridges between upon temperature induced separation. In this work, we show suspensions can be formed mixi...

The loss of water from hardened concrete (stored in unsaturated air) causes drying shrinkage. Shrinkage of hardened concrete is influenced by various factors in a similar manner to creep under drying conditions. High cementitious materials content, particularly fine particles will reduce bleeding, but increase long term drying shrinkage. (The time of sawing the joints for induced cracking is no...

We find that Mycobacterium smegmatis survives spray drying and retains cell viability in accelerated temperature stress (40 °C) conditions with a success rate that increases with increasing thermal, osmotic, and nutrient-restriction stresses applied to the mycobacterium prior to spray drying. M. smegmatis that are spray dried during log growth phase, where they suffer little or no nutrient-redu...

Prior to registration of crop protection products (CPPs) their persistence in soil has to be determined under defined conditions. For this purpose, soils are collected in the field and stored for up to 3 months prior to the tests. During storage, stresses like drying may induce changes in microbiological soil characteristics (MSCs) and thus may influence CPP degradation rates. We investigated t...

Developing recombinant protein pharmaceuticals has proved to be very challenging because of both the complexity of protein production and purification, and the limited physical and chemical stability of proteins. To overcome the instability barrier, proteins often have to be made into solid forms to achieve an acceptable shelf life as pharmaceutical products. The most commonly used method for p...

The precise pore sizes defined by crystalline zeolite lattices have led to intensive research on zeolite membranes. Unfortunately, zeolites have been extremely difficult to prepare in a defect-free thin film form needed for membrane flux and selectivity. We introduced tetrapropylammonium (TPA), a structure-directing agent for zeolite ZSM-5, into a silica sol and exploit the development of high ...

in the traditional hole drilling method the in-plane stresses are studied in detail and the interlaminar stresses are not taken seriously. the interlaminar stresses on the free edge of composite materials are important and can cause matrix cracking and delamination. inserting holes in composite laminates causes free edges and it can induce interlaminar shear and normal stresses. in this researc...