The purpose of this study was to evaluate the microhardness of resin-based materials polymerized with a LED (light-emitting diode) light-curing unit (LCU) and a halogen LCU. Twenty cylindrical specimens (3.0 mm in diameter and 2.0 mm high) were prepared for each tested material (Z100, Definite and Dyract). Specimens were light-cured with two LCUs (Ultraled and Curing Light 2500) for either 40 o...

Introduction: The degree of polymerization depends on the type of light-curing unit. The aim of this study was to compare the hardness of composite resin cured by LED and Halogen light curing units. Methods: In this experimental study, 20 cylindrical samples of Tetric Ceram composite were prepared. Half of them were cured with Ultralume 2 LED and the other half with Astralis 7 Halogen light cur...

Our objective was to carry out a prospective, randomized, single-blind study to evaluate whether light emitting diode (LED) phototherapy using a low-cost set of lights is as effective as conventional phototherapy in treating hyperbilirubinemia in neonates. The study included 45 pre-term neonates requiring phototherapy as per American Academy of Pediatrics guidelines; participants were randomize...

The goal of this work is to understand how the processing of motion under the conditions created by blowing snow causes drivers to fail to detect that they are approaching a vehicle ahead. Color was examined under blowing snow conditions to assess whether an equiluminant (equal brightness) situation was created. In this situation, contrast in light level is not detected but differences in color...

PURPOSE To measure the amount of light energy that dental students actually deliver to a Class I preparation in a dental mannequin. MATERIALS AND METHODS Approval for the study was obtained from the Dalhousie University Health Sciences Research Ethics Board. Each of 20 third-year dental students light-cured a Class I preparation in tooth 27 in a mannequin head. A photodetector located at the ...

OBJECTIVES The aim of this study was to investigate microhardness and compressive strength of composite resin (Tetric-Ceram, Ivoclar Vivadent), compomer (Compoglass, Ivoclar, Vivadent), and resin modified glass ionomer cement (Fuji II LC, GC Corp) polymerized using halogen light (Optilux 501, Demetron, Kerr) and LED (Bluephase C5, Ivoclar Vivadent) for different curing times. METHODS Samples ...

The purpose of this study was to evaluate the polymerization effectiveness of a composite resin (Z-250) utilizing microhardness testing. In total, 80 samples with thicknesses of 2 and 4 mm were made, which were photoactivated by a conventional halogen light-curing unit, and light-curing units based on LED. The samples were stored in water distilled for 24 h at 37 ° C. The Vickers microhardness ...

introduction: the aim of this study was to in-vestigate the effect of irradiation duration and distance of light tip to prepared samples in two different light curing unites on the degree of conversion of resin composite. materials and methods: conventional halogen and blue light emitting diode (led) units were used for polymerization of an opalis resin com-posite. the conversion measurements w...

INTRODUCTION In this in-vitro study, we evaluated the temperature changes in the pulp chamber during bracket bonding using 4 different light sources. METHODS Eighty intact extracted maxillary central incisors were used. The teeth were divided into 4 groups of 20 teeth each. Brackets (Mini Twin, Dentaurum, Ispringen, Germany) were bonded with Transbond XT (3M Unitek, Monrovia, Calif) adhesive ...