The friction properties of an aluminum-silicon alloy (Al-Si) can be improved by increasing its silicon content. However, this deteriorate the material necessary for engine components. Therefore, alternative approach to reduce is required. This study investigated running-in behavior, reduction from initial stable phase sliding, between Al-Si with varying contents and bearing steel in fully formu...

Roll-to-roll processing of thin film solar cells on flexible low cost substrates is an attractive option to lower the production cost of photovoltaic modules. Plastic substrates like PET or PEN are insulating which potentially offers advantages compared to conducting steel foils. However, plastic substrates require lower processing temperatures and novel schemes for efficient light trapping. In...

This paper presents the design of a ring-shaped tri-axial fore sensor that can be incorporated into the tip of a guidewire for use in minimally invasive surgery (MIS). The designed sensor comprises a ring-shaped structure located at the center of four cantilever beams. The ringdesign allows surgical tools to be easily passed through which largely simplified the integration process. Silicon nano...

Neutron reflectometry has been successfully used to study adsorption on a stainless steel surface by means of depositing a thin steel film on silicon. The film was characterized using XPS (X-ray photoelectron spectroscopy), TOF-SIMS (time-of-flight secondary ion mass spectrometry), and GIXRD (grazing incidence X-ray diffraction), demonstrating the retention both of the austenitic phase and of t...

The mechanism by which relatively small concentrations of silicon influence the precipitation of cementite from carbon supersaturated austenite and ferrite are investigated. It is found that one condition for the retardation of cementite is that the latter must grow under para-equilibrium conditions, i.e. the silicon must be trapped in the cementite. However, this is not a sufficient condition ...

Ti-Si-C thin films were deposited onto silicon, stainless steel and high-speed steel substrates by magnetron sputtering, using different chamber configurations. The composition of the produced films was obtained by Electron Probe Micro-Analysis (EPMA) and the structure by X-ray diffraction (XRD). The hardness and residual stresses were obtained by depth-sensing indentation and substrate deflect...

Important problems in load cells are creep and hysteresis. Expensive high grade steels are used in order to reduce these effects. In this paper a silicon load cell design is presented which is based on a force-to-liquid-pressure transformation. The design is insensitive to hysteresis and creep, can be made at very low costs and is able to measure loads up to 1000 kg with an accuracy of 0.03 %. ...