dynamic recrystallization, drx, behaviour of a precipitation hardened, ph, stainless steel was studied in connection with microstructural developments in a compression test. the experimental results showed that the dominant mechanism of softening is drx, but at high strain rates and low temperatures, ie, high zener-holman parameter, z, work hardening and dynamic recovery, drv, produced a pancke...

the effects of carbon content on the dynamic and static softening mechanisms of ti microalloy steels were investigated both in ferrite and austenite regions. the results obtained showed that recrystallization rate decreased as the percentage of carbon content was increased from 0.0035 to 0.110. this is due to the ti(cn) and tic precipitates and also the free carbon content. in the ferrite regio...

The hot deformation behavior of a Fe–22Cr–25Ni–3.5W–3Cu–1.5Co super-austenitic stainless steel was investigated using isothermal compression tests with a wide range of temperatures (1173–1373 K) and strain rates (0.1–10 s). The results showed that all the flow curves gradually turned to balanced stress state without notable peak stress characteristics during the entire deformation, which indica...

A new biomaterial Ti–14Cr alloy was designed for biomedical applications. The manufacturing process of Ti alloys through hot deformation is crucial controlling the grain structure and mechanical performance alloy. In present study, several compression tests at elevated temperatures (1123–1273 K) strain rate ranges 0.01–10 s−1 were conducted using a Gleeble-3800 thermomechanical simulator. proce...

The aim of this study is to investigate the nucleation of new grains by necklacing mechanism during dynamic recrystallization (DRX). The material used is 316 stainless steel. In order to modeling the deformation behavior during hot rolling, one-hit compression tests were performed at temperature range of 950-1100 °C with strain rates of 0.01-1s-1. The result shows that at the tempera...

During quenching, hot rolled steel rings, especially those with a large outer diameter to wall thickness ratio, distort and develop undesired residual stresses. These phenomena are the result of three major mechanisms: metallurgical, mechanical and thermal. This paper presents the result of a comprehensive study on the heat treatment of rings by modeling via Finite Element Analysis. The simulat...

P. Kawulok, I. Schindler, R. Kawulok, S. Rusz, P. Opěla, J. Kliber, M. Kawuloková VSB – Technical University of Ostrava, Faculty of Metallurgy and Materials Engineering, Czech Republic Z. Solowski, K.M. Čmiel Třinecké železárny a.s., Czech republic Formability of hypereutectoid C-Mn-Cr-V steel in hot condition was investigated with use of plastometric methods. A wide range of deformation temper...