In this research, the influence of adding micro- and nano- sized calcium carbonate powders to nylon-66 was investigated. Mechanical properties of micro and nano- composites, including tensile strength, elongation, and Young’s modulus, before and after ageing, were determined and analyzed. For this purpose, micro- and nano-sized CaCO3 particles were used as fillers to prepare micro-composites (c...

The project aims to study tensile softening behavior of fiber reinforced concrete .Concrete is very much weak in tension but by addition of randomly oriented short crimped steel fibers will change the behavior from brittle to ductile. In the present work, the steel fibers were added at the volume fraction, being 0%, 0.5%, 1%, 1.5% to the normal strength concrete and high strength concrete. The ...

background and aims. polymethyl methacrylate, pmma, is widely used in prosthodontics for fabrication of removable prostheses. this study was undertaken to investigate the effect of adding silver nanoparticles (agnps) to pmma at 2% and 0.2% concentrations on compressive and tensile strengths of pmma. materials and methods. the silver nanoparticles were mixed with heat-cured acrylic resin in an a...

background and aims. although microwave irradiation has been used for disinfection of dental stone casts, there are concerns regarding mechanical damage to casts during the process. the aim of this study was to evaluate the effect of microwave irradiation on the compressive strength (cs) and diametral tensile strength (dts) of stone casts. materials and methods. in this in vitro study, 80 cylin...

Effects of nutshell fiber loadings of 30 wt.% and MCC loadings up to 15 wt.% on some properties of high-density polyethylene composites (HDPE) were investigated. The composites were manufactured by a single screw extruder and injection molding. The experimental composite samples were tested for their mechanical performance including tensile strength, tensile modulus, flexural strength, flexural...

Rapid heat cycle molding (RHCM) is a special molding process capable of producing molded plastic parts with high surface quality and improved weldline strength and appearance. This study investigated the influence of the weldline on the tensile strength of RHCM and conventional injection molded (CIM) components. The test specimens with and without a weldline were cut from RHCM and CIM parts for...

The aim of the present work was to study the effect of various process parameters i.e. current, voltage, travel speed, electrode diameter, flux composition, pre heating of workpiece, electrode stick-out and edge including angle on changes in tensile strength and toughness of the weld bead geometry of HSLA Steel and to optimize the process so that minimal changes occur in the material properties...

It is commonly proposed that the fatigue strength can be enhanced by increasing the tensile strength, but this conclusion needs to be reconsidered according to our study. Here a recrystallized α-Cu-15at.%Al alloy with moderate grain size of 0.62 μm was fabricated by cold rolling and annealing, and this alloy achieved exceptional high fatigue strength of 280 MPa at 10(7) cycles. This value is mu...

Using molecular dynamics we find that the tensile strength of the contacts between two clean platinum surfaces with nanoscale asperities is strongly size dependent with a maximum strength for contact lengths of approximately 5 nm. This is the first time a strongest size is observed in single crystals. The strengthening with decreasing size down to 5 nm results from a decrease in the initial den...