A novel low noise trans-impedance amplifier is proposed using low cost 0.18 µm CMOS technology. A resistive-capacitive feedback is used to extend the bandwidth of the amplifier. As the structure is inductor less, it is suitable for low cost integrated optical interconnects. In this paper Improved Particle Swarm Optimization have applied to determine optimal trans-resistance and noise of propose...

1. Introduction The goal of an optical fiber communication system is to transmit the maximum number of bits per second over the maximum possible distance with the fewest errors. A typical digital fiber optic link is depicted in Figure 1. Electrical data signals are converted to optical signals via a modulator. A " 1 " is transmitted as a pulse of light while a " 0 " has no light output. The num...

Optical parametric amplification is a process that leads to the generation of quantum states of light. In the limit of low single-pass gain, this process is often referred to as parametric down conversion, and produces entangled two-photon states. Such states have played a key role in recent studies of quantum optical effects such as quantum teleportation. As the gain of the parametric amplific...

The Raman polarizer is a Raman amplifier which not only amplifies but also repolarizes light. We propose a relatively simple and analytically tractable model - the ideal Raman polarizer, for describing the operation of this device. The model efficiently determines key device parameters such as the degree of polarization, the alignment parameter, the gain and the RIN variance.

We observe clamping of the output spatial light distribution of a waveguide array. Using a chirped pulse amplifier we reach peak intensities in the waveguides of ~24 GW/cm2. At this level, three photon absorption in the AlGaAs material clamps the discrete spatial soliton to a set distribution. Further increase in intensity does not change the distribution.

Optimal gain spectra minimizing distortion and enhancing delaying efficiency in linear slow light systems are predicted and experimentally validated by shaping the gain spectral profile in a Brillouin fiber amplifier. OCIS codes: (060.4370) Nonlinear optics, fibers; (290.5900) Scattering, stimulated Brillouin; (350.5500) Propagation

An all-optical AND gate based on optically induced nonlinear polarization rotation of a probe light in a bulk semiconductor optical amplifier is realized at a bit rate of 2.5Gbit/s. By operating the AND gate in an up and inverted wavelength conversion scheme, the extinction ratio is improved by 8dB compared with previously published work.

We report a dramatic improvement of the spatial coherence and beam divergence (0.66 mrad) of a 13.2 nm wavelength Ni-like Cd tabletop laser by injection seeding the soft x-ray laser amplifier with high-harmonics pulses generated in a Ne gas jet. This phase coherent laser is an attractive light source for at-wavelength interferometry of extreme ultraviolet lithography optics and other applications.

The frequency-dependent group delay of dielectric mirrors was measured by spectrally resolved white-light interferometry. Chirped mirrors and thin-film Gires-Tournois interferometers designed for dispersion control in a femtosecond Ti:sapphire laser oscillator-amplifier system were tested with a group-delay resolution of +/-0.2 fs and a spectral resolution of ~1 nm over the spectral range of 67...