Results are presented for physical experiments that illustrate the possibilities and efficiency of visualization for studying the effect of operating conditions (backward-facing stepped forming nozzle, exit diameter of anode, mass flow, and composition of working gas) on plasma flows at low Reynolds numbers for advanced coating and powder processing. In particular, the shadow method, based on a...

Nanostructured SnO2 thin films were prepared by ultrasonic spray pyrolysis technique. Aqueous solution (0.05M) of SnCl4·5H2O in double distilled water was chosen as the starting solution for the preparation of the films. The stock solution was delivered to nozzle with constant and uniform flow rate of 70 ml/h by Syringe pump SK5001. Sono-tek spray nozzle, driven by ultrasonic frequency of 120 k...

Pontryagin's principle is used to study the shape of the supersonic part of the nozzle of a carbon dioxide gas-dynamic laser whose gain is maximal. The exact shape is obtained for the uncoupled approximation of Anderson's bimodal model. In this case, if sharp corners are allowed, the ceiling of the supersonic part consists of a slant rectangular sheet followed by a horizontal one; otherwise...

Measurements were made of the flow field structure and the near field parameters of a jet exhausting from a sonic nozzle with a 1.27 cm exit diameter. Compressed air was used for obtaining stagnation pressures up to ~ 5 atmospheres. The jet exhausted vertically from a settling chamber into an acoustically insulated room and through an insulated duct out through the roof. Measurements were made ...

This paper presents the performance analysis results of a short line fault interruption of a gas circuit breaker, particularly a self-blast type breaker. Hot gas flow analysis was carried out using a CFD calculation combined with the arc model and nozzle ablation. To evaluate the interruption performance, the index function was defined using the pressure in the heating chamber and the density a...

As a sequel to our previous effort on the modeling of particle motion through a single lens or nozzle, flows of gas–particle suspensions through an integrated aerodynamic-lens–nozzle inlet have been investigated numerically. It is found that the inlet transmission efficiency (ηt) is unity for particles of intermediate diameters (Dp ∼ 30–500 nm). The transmission efficiency gradually diminishes ...

Air pollution is one of the major issues about the diesel engines in todays' world. It is a special concern in those areas that have difficulty meeting health-based outdoor air quality standards. Natural gas has low emission and resource abundance and also conventional compression ignition engine can be easily converted to a dual fuel mode to use natural gas as main fuel and diesel as pilot ...

A method for quantitative measurements of gas and liquid distributions is demonstrated using simultaneous x-ray fluorescence and radiography of both phases in an atomizing coaxial spray. Synchrotron radiation at 10.1 keV from the Advanced Photon Source at Argonne National Laboratory is used for x-ray fluorescence of argon gas and two tracer elements seeded into the liquid stream. Simultaneous t...

A thermodynamic process of power generation has been developed for a gas turbine, a steam turbine, and a compressor, supported by adiabatic expansion or compression processes. Recently, the possible inlet temperature of gas turbines has been increased to 1500°C or more, and the inlet temperature of steam turbines also has been increased to 650°C. At these high-temperature conditions, turbine no...