BACKGROUND Phase-2 voltage and maximum pulse width are dependent on phase-1 pulse characteristics in a single-capacitor biphasic waveform. The use of 2 separate output capacitors avoids these limitations and may allow waveforms with lower defibrillation thresholds. A previous report also suggested that the optimal tilt may be >70%. This study was designed to determine an optimal biphasic wavefo...

Based on the fact that the real inductor and the real capacitor are fractional order in nature and the fractional calculus, the transfer function modeling and analysis of the open-loop Buck converter in a continuous conduction mode (CCM) operation are carried out in this paper. The fractional order small signal model and the corresponding equivalent circuit of the open-loop Buck converter in a ...

An active filter-based on-chip DC–DC voltage converter for application to distributed on-chip power supplies in multivoltage systems is described in this paper. No inductor or output capacitor is required in the proposed converter. The area of the voltage converter is therefore significantly less than that of a conventional low-dropout (LDO) regulator. Hence, the proposed circuit is appropriate...

A closed-loop high-gain switched-coupled-inductor switched-capacitor (SCISC) converter is proposed by combining a sawtooth wave generator, pulse-widthmodulation based (PWM based) compensator and nonoverlapping circuit for step-up DC-DC conversion and regulation. The power part between source VS and output VO contains two sub-circuits: (i) a switched-coupled-inductor (SCI) booster circuit, and (...

In this work a new design of a t u n a b l e c a p a c i t o r b a s e d o n microelectromechanical system (MEMS) technology is presented. The design of high Qtunable capacitor has been accomplished through bulk micromachining process with all metal microstructure. A standard IC fabrication process (HP.5μ) is used to carry out the tunable capacitor. The main features of this high-Q MEMS tunable...

A new technique to measure a capacitor or a capacitive sensor by means of a direct sensor-to-microcontroller interface circuit that does not need a calibration capacitor is proposed. Basically, the measurement process consists of three consecutive steps of charge, discharge and charge of the capacitor under test. A non-linear equation is obtained and solved that is dependent only on known circu...

The goal of internal frequency compensation of a low dropout voltage regulator (LDO) is the selection of a small-value, ESR-independent output capacitor. Cascode compensation formed by a common-gate transistor acting as a current buffer, an optional series resistor, and a compensation capacitor creates a dominant pole and a left-halfplane (LHP) zero, allowing adequate phase margin and stable LD...

An active filter-based on-chip DC–DC voltage converter for application to distributed on-chip power supplies in multivoltage systems is described in this paper. No inductor or output capacitor is required in the proposed converter. The area of the voltage converter is therefore significantly less than that of a conventional low-dropout (LDO) regulator. Hence, the proposed circuit is appropriate...