whereas in electrical discharge machining (edm) the heat flux entering the workpiece is extremely high, the fourier heat conduction model may fails. this article reports on determination of temperature distribution in the workpiece due to edm using non-fourier heat conduction model. equations are solved by deriving the numerical solution. the temperature layers and profiles of sample calculatio...

The objective of this study is to find the temperature distribution of a slab as it moves through the pusher-type preheat furnaces. First, the imaginary planes method (IPM) as a new and applicable method for calculation of radiation heat transfer in industrial furnaces is studied, and the two-dimensional form of this method is used to calculate heat flux and temperature distribution in the furn...

This paper presents the heat transfer coefficients and the pressure drop measured during HC-600a (Isobutane) condensation inside a brazed plate heat exchanger: the effects of saturation temperature, refrigerant mass flux and vapour super-heating are investigated. The heat transfer coefficients show weak sensitivity to saturation temperature and great sensitivity to refrigerant mass flux. At low...

Heat flux from convection in Earth's mantle has recently been suggested to vary substantially (20–30%) with the Wilson cycle of continental aggregation and dispersal, because of possible changes in the aspect ratio of convective cells, and the present-day heat flux may be at the maximum at such a temporal variation. This possibility of strong temporal fluctuations in heat flux has an important ...

Mathematical model of direct and inverse problems is developed for the flat plate probe which is subjected to timedependent heat flux at one end, while the other end is kept insulated. The direct solution, which is concerned with determination of the temperature distribution in the probe, is developed using an approach based on the method of variation of parameters. The direct solution is used ...

in the nighttime, drainage flow occurs along the basin sideslope and advects cold air to the boundary layer over the basin bottom (bbl), intensifying the cooling rate of the layer. a nocturnal cold air lake develops in the basin, attaining a depth nearly equal to the topographical depth of the basin. heat budget analysis of the whole basin surface shows that net radiative flux closely balances ...

Pool boiling heat transfer characteristics of Al2O3 -water nanofluids is studied experimentally using a NiCr test wire of 36 standard wire guage diameter. The experimental work mainly concentrated on (1) change of critical heat flux with different volume concentrations of nanofluid and (2) flow visualization of pool boiling using a fixed concentration of nanofluid at different heat flux values....

fire behavior of different types of eps was evaluated with the use of iso 5660 cone calorimeter test method. considering the complexity of behavior of eps against high temperatures, several specimens were tested, so a betterjudgment on fire behavior of this material could be acquired. the effects of foam density, thickness of specimens and the level of heat flux on fire behavior of foam were ex...