Co-Continuous Ceramic Composites, referred to as C4, have bi-continuous, interconnected and interpenetrating phases of a metal and ceramic. This bestows such composites with a higher strength to weight ratio compared with traditional composites. In this research work, a C4 composite of AA5083/SiC is fabricated for personal body armour, using gravity infiltration technique. A numerical simulatio...

This paper presents our experience towards the conception of a virtual reality medical simulator coupled with haptic interaction aimed at training surgeons. This area of research has a long history and a wide variety of approaches have been used. Generally, human tissue can be considered as a deformable body of viscoelastic material. To enable dynamic simulation of these bodies, we have patched...

Differentiated Services (Diffserv) which was proposed by Internet Engineering Task Force (IETF), is a scalable and robust model for providing the end-to-end QoS. In the Diffserv networks, metering mechanisms are used to measure traffic stream. The single rate Three Color Meter (srTCM) [1],which was proposed by IETF,‏ meters an IP packet stream and marks its packets either green, yellow, or red....

the built up layer thickness in secondary deformation zone is one of the important parameters in metal cutting process. the built up layer (bul) is formed in second deformation zone near the tool-chip interface in the back of the chip. this parameter influences the tool life and machined surface quality. this bul should not be confused with the built up edge (bue). the deformation of the bul in...

in this research, our attempt is to monitor tool wear through the chip formations, forces, and temperature of edge of drill while drilling in superalloy plate to optimizes effective parameters, which lead to facilitate machining process to, improved tool life, and enhance the productivity. in this study, inconel718 superalloy material, and cemented coated carbide tool was selected for investiga...

Fiber-reinforced polymeric composites are used widely due to their unique properties of light weight, stiffness and high strength weight ratio. During processing and servicing, the composite materials undergoes delamination, and petalling. Computational model was constructed for finite element modeling to reflect material purpose under impact load and relevant material properties were taken. In...

Under the action of Arctic low temperatures and long-term alternating loads, fatigue life submarine rudder stock mechanism is severely tested. In this paper, research method static strength analysis proposed by combining multibody dynamics, finite element method, tests. Based on three-dimensional model motion law mechanism, a dynamic established, time history loads each node are obtained. Accor...

the problem of relative motion control for spacecraft formation flying in eccentric orbits is considered in this paper. due to the presence of nonlinear dynamics and external disturbances, a robust fuzzy sliding mode controller is developed. the slopes of sliding surfaces of the conventional sliding mode controller are tuned according to error states using a fuzzy logic and reach the pre-define...