As the second part to a paper presented at the 2004 SMTA Pan Pacific Symposium, this paper further summarizes the results from technical qualification of the Ni/Pd/Au process. Whereas the previous paper examined the wire bonding capabilities of this surface finish, this second paper focuses specific attention to BGA applications. In these investigations, the solder joint integrity is measured u...

Shearography is a full field interferometric technique for the measurement of small deformation gradients. The main applications are non-destructive testing in material inspection and quality control. This contribution intends to present a new image shearing speckle pattern interferometer set-up for simultaneous measurement of two independent deformation gradients equivalent to two shear direct...

objective: different ceramic repair systems have been reported for fractured ceramics. however, limited information is available concerning the bond strength of these systems especially after thermocycling. the aim of this in-vitro study was to determine the effect of thermocycling on the shear bond strength of composite-resin to feldspathic porcelain with and without silane pretreatment. mater...

Hygrothermal environments can degrade anisotropic conductive adhesive (ACA) joints by weakening the shear strength of adhesive interface. In this paper, the shear strength degradation model of ACA joints under hygrothermal conditions was formulated through experimental testing and theoretical modeling. The shear strength degradation data were obtained from different hygrothermal aging tests and...

The strain rate sensitivity (SRS) of Mg–1.5 wt% Gd processed by conventional extrusion and 2 passes of simple shear extrusion (SSE) was investigated by shear punch testing. Shear punch tests were conducted at initial shear strain rates in the range of 0.003–0.3 s-1 and at temperatures in the range of 573–773 K. A fine-grained microstructure with an average grain size of about 2.5 µm, obtained a...

The present study focusses on the damping force control of shear mode magnetorheological (MR) damper for seismic mitigations. Therefore, the semi-active MR damper which can control the vibration is analyzed both experimentally and numerically. Carbonyl iron is used as the magnetic particle and Castrol Magnetec oil as carrier fluid throughout the study. MR damper is designed and fabricated, and ...

Introduction: Amalgam, which can be applied with or without dowel, is one of the commonly used restorative materials for core restoration in pulpless teeth. The current study aimed to compare the shear strength of amalgam cores with and without dowel. Methods: A total number of 20 recently extracted mandibular premolars were assigned to two groups of 10 equal s...

statement of problem: shear bond strength (sbs) of home and office bleached enamel will be compromised by immediate application of composite restoration. antioxidant agent may overcome this problem. objectives: this in vitro study assessed the effect of green tea extract on shear bond strength of resin composite to in-office and home-bleached enamel. materials and methods: in this experimental ...

Introduction: One of the clinical problems in orthodontics is the bonding of brackets tocomposite restorations. The aim of this study was to evaluate the shear bondstrength of brackets bonded to composite restorations using Excite. Methods:Forty brackets were bonded to composite surfaces, which were embedded inacrylic resin. One of the following four protocols was employed for surfacepreparatio...