A SnO/SnO2/GNS composite with controlled oxidation states and composition has been prepared through simple one-pot reduction of an EG suspension of SnCl2 and graphene oxide. The as-prepared composite was characterized by XRD, FT-IR, XPS, SEM, TEM and BET. SnO and SnO2 nanoparticles are uniformly distributed on the surface of the graphene. Taking advantage of the high electron conductivity of gr...

2D TiO2 thin films and 3D flower-like TiO2-based nanostructures, also decorated with SnO2, were prepared by chemical and thermal oxidation of Ti substrates, respectively. The crystal structure, morphology and gas sensing properties of the TiO2-based sensing materials were investigated. 2D TiO2 thin films crystallized mainly in the form of rutile, while the flower-like 3D nanostructures as anata...

Construction of metal oxide nanoparticles as anodes is of special interest for next-generation lithium-ion batteries. The main challenge lies in their rapid capacity fading caused by the structural degradation and instability of solid-electrolyte interphase (SEI) layer during charge/discharge process. Herein, we address these problems by constructing a novel-structured SnO2-based anode. The nov...

Li-doped ZnO (LZO) aggregated nanoparticles are used as an insulating layer in SnO2 nanocomposite (SNC) photoanodes to suppress the recombination process in dye-sensitized solar cells (DSSCs). Various weight percentages of SnO2 nanoparticles (SNPs) and SnO2 nanoflowers (SNFs) were used to prepare SNC photoanodes. The photocurrent-voltage characteristics showed that the incorporation of an LZO i...

Nanowires (NWs) and nanobelts (NBs) are considered as ideal building blocks for constructing nanosized devices due to high surface to volume ratio and their special physical and chemical properties resulting from the reduced sizes. Until now, many semiconductor NWs/NBs have been successfully applied in nanodevices, including nanolasers,1 nanogenerators,2 and various chemical and biological nano...

Related Articles Single and multi-particle passive microrheology of low-density fluids using sedimented microspheres Appl. Phys. Lett. 102, 074101 (2013) Dose enhancing behavior of hydrothermally grown Eu-doped SnO2 nanoparticles J. Appl. Phys. 113, 064306 (2013) Why specific mixed solvent composition leads to appropriate film formation of composite during spin coating? Appl. Phys. Lett. 102, 0...

The development of alternative anode materials out of flexible composite nanofibers has seen a growing interest. In this paper, binary carbon nanofiber electrodes of SnO2/NiO and Sn nanoparticles are produced using a scalable technique, Forcespinning (FS), and subsequent thermal treatment (carbonization). The Sn/C composite nanofibers were porous and flexible, while the SnO2/NiO composite nanof...

Tin oxide nanoparticles have been prepared by conventional sol-gel technique. Research grade tin chloride (SnCl2.2H2O) was used as tin and zinc sources. Ethylene glycol and alcohol were used as solvents under different synthesis conditions. Transparent un-doped SnO2 sol was prepared after continuous stirring and refluxing at 40C. Thin films, prepared from SnO2 sol, have also been deposited on g...

Tin oxide (SnO2) hollow spheres modified with titanium dioxide (TiO2) nanowires (NWs) synthesized by sequential hydrothermal reactions were investigated as photoanodes for dye-sensitized solar cells. Not only does the hydrothermal treatment form numerous short TiO2 NWs on the surface of SnO2 spheres, but also passivates the surface of SnO2. Consequently, the specific surface area of the photoan...

in this study, we investigated the effect of using large tio2 nanoparticles in the matrix of small nanoparticles to improve the performance of dye-sensitized solar cells (dsscs), as light scatter to increase the light harvesting. the mixed powder was deposited by electrophoretic deposition (epd) on fto (f-sno2 coated glass). it is shown that adding small quantity of larger nanoparticles can enh...