INTRODUCTION Cross-flow turbines present several advantages over axial flow types for power generation from moving water. First, the rectangular form factor is well suited to take advantage of the hydrokinetic energy often concentrated in shallow channels. This form factor presents an opportunity to construct arrays with high blockage (ratio of swept area to channel cross-sectional area), poten...

Field measurements of the wake flow produced from a 2-MW Enercon E-70 wind turbine were performed using three scanning Doppler wind lidars. A GPS-based technique was used to determine the position of the wind turbine and the wind lidar locations, as well as the direction of the laser beams. The lidars used in this study are characterized by a high spatial resolution of 18 m, which allows the de...

The efficiency of a gas turbine largely depends on the aerodynamics and pressure recovery capacity diffuser. For reliable numerical simulation flow in diffuser, model must be validated basis experimental data structure. An study stage diffuser system was carried out. results this investigation are as follows: area applicability method for assessing determined; recommendations preparing transfer...

in this paper, the fluid-structure interaction phenomenon and the research history are described. then due to the complex and specific working conditions of a turbine blade, we have investigated the phenomenon on this subject. the fluid-structure interaction on a turbine blade model has been simulated by using structural and fluid flow section of ansys software. a model of turbine blade with ai...

Significance of the Problem Control of blade-tip clearance in the compressor and turbine sections of gas turbine engines can improve efficiency, minimize leakage flow, and shorten engine development time. Tip clearance varies throughout different operating conditions (e.g., start-up, idle, full power, shut-down) because of different radial forces and different thermal expansion coefficients and...

The need of a continuous improvement in gas turbine efficiency for propulsion and power generation, as well as the more demanding operating conditions and power control required to these machines, still ask for great efforts in the design and analysis of the high pressure section of the turbo-expander. To get detailed insights and improve the comprehension of the flow physics, a wide experiment...

Vertical turbine pumps are designed to operate with the pump shafts in tension (downthrust). Most pump and motor manufacturers caution users to not operate the vertical turbine pumps at conditions that result in “upthrust.” Upthrust conditions are usually encountered for a few seconds each time the pump is started; however, the pump should not be operated for periods longer than a few seconds i...

Unlike conventional hydro and tidal barrage installations, water current turbines in open flow can generate power from flowing water with almost zero environmental impact, over a much wider range of sites than those available for conventional tidal power generation. Recent developments in current turbine design are reviewed and some potential advantages of ducted or “diffuser-augmented” current...