نتایج جستجو برای: strain energy release rate

تعداد نتایج: 1932348  

Journal: :Journal of Physics: Conference Series 2013

Journal: :Structural and Multidisciplinary Optimization 2018

2015
Ali Abdul-Aziz Ramakrishna T. Bhatt Joseph E. Grady ALI ABDUL-AZIZ RAMAKRISHNA T. BHATT JOSEPH E. GRADY

This article discusses results obtained from a parametric study to analytically evaluate the impingement of a crack at the interface of an environmental barrier coating (EBC) and a monolithic Silicon nitride (Si 3 N 4) layered ceramics substrate. The study establishes a correlation that leads to determine if the crack is arrested or advanced by either penetrating or deflecting along the EBC/sub...

In this research, the hot deformation behavior of W360 tool steel was investigated using hot compression test at 1000-1200°C and strain rates of 0.001, 0.01, 0.1, and 1 s-1. According to the results, dynamic recrystallization was found the most important restoration factor of this alloy during hot deformation. Recrystallization was enhanced with an increase in temperature and strain rate. Also,...

2016
Omar Rodriguez Ali Matinmanesh Sunjeev Phull Emil H. Schemitsch Paul Zalzal Owen M. Clarkin Marcello Papini Mark R. Towler

Silica-based and borate-based glass series, with increasing amounts of TiO₂ incorporated, are characterized in terms of their mechanical properties relevant to their use as metallic coating materials. It is observed that borate-based glasses exhibit CTE (Coefficient of Thermal Expansion) closer to the substrate's (Ti6Al4V) CTE, translating into higher mode I critical strain energy release rates...

Journal: :Journal of dental research 1977
J C Roberts J M Powers R G Craig

Fracture toughness, critical strain energy release rate, and critical stress intensity factor were determined for experimental and commercial restorative resins. A composite resin had lower resistance to crack initiation than an unfilled acrylic resin. The data were consistent with surface failure observed in single-pass wear studies of these resins.

2002
Ivone Jiménez-Munt Roberto Sabadini

[1] The geodetic velocity and strain rate patterns in Anatolia constrain the rheology of the lithosphere, once compared with thin shell finite element tectonic model predictions. Geodetic and modeled deformation favors a hard lithospheric rheology, responsible for the high EastWest horizontal velocities in the center of Anatolia, between 39 –41 N, in proximity of the North Anatolian Fault. The ...

نمودار تعداد نتایج جستجو در هر سال

با کلیک روی نمودار نتایج را به سال انتشار فیلتر کنید