In simple terms, the wood cell wall is a composite made of a rigid cellulose polymer in a matrix of lignin and the hemicelluloses. The lignin polymer in the middle lamella and S2 layer is thermoplastic; that is, it softens upon heating. The glass transition temperature Tg of the lignin in the matrix is approximately 170°C (338°F). Above the matrix Tg, it is possible to cause the lignin to under...

The large strain nonlinear stress-strain behavior of thermoplastic polyurethanes (TPUs) exhibits strong hysteresis, rate dependence and softening. Thermoplastic polyurethanes are copolymers composed of hard and soft segments. The hard and soft segments phase separate to form a microstructure of hard and soft domains typically on a length scale of a few tens of nanometers. Studies have revealed ...

Nanoimprint lithography (NIL) is a technology where fine structures on a mold (or template) are transferred onto a substrate coated with thermoplastic or with ultraviolet (UV) curing resins by making contact with the substrate while being heated or exposed to UV lights. Recently, NIL has been applied in semiconductor manufacturing to print fine features of circuits on LSI chips and memories at ...

Carbon nanofibers (CNFs) have been synthesized from thermoplastic polyvinylpyrrolidone (PVP) using electrospinning in combination with a novel three-step heat treatment process, which successfully stabilizes the fibrous morphology before carbonization that was proven to be difficult for thermoplastic polymers other than polyacrylonitrile (PAN). These CNFs are both mesoporous and microporous wit...

Schlieren interferometry is found to be an alternative tool for temperature measurement during thermoplastic laser welding with regard to methods based on thermocouples or optical pyrometers. In fact, these techniques are not easily applied when materials to be processed have reduced thickness, negligible heat conduction, and low emissivity, as is the case of welding high-density polyethylene f...

In the context of modern engineering practice, this paper describes the exploitation of thermoplastic materials for the provision of lightweight, low cost, corrosion free, alignment devices for lower limb prostheses. After setting out design requirements, four newly developed devices are described and discussed. These are respectively a four jack system, a serrated wedge system, a spherical ali...

Thermoplastic rubbers are materials that combine the characteristics of good processability of thermoplastics with the physical properties of vulcanized rubber. SEBS is a SBS which has been subjected to a hydrogenation process, through the polybutadiene chain is eliminated. This new rubber has a high resistance to environment, temperature, UV radiation, etc. without losing the properties of a t...

Deterioration of bridges in the United States has been well recognized. According to the FHWA National Bridge Inventory, one third of nearly 600,000 U.S. highway bridges are classified as structurally deficient or functionally obsolete. Since the majority of bridges were built using wood, steel or concrete, the same conventional materials have been used for bridge replacement or rehabilitation,...