a simple and green synthetic strategy to prepare bao/tio2-zro2 as a solid base catalyst was reported. these materials with various amounts of bao were prepared by the adsorption method. the physical and chemical properties of bao/tio2-zro2 were investigated by x-ray diffraction, x-ray fluorescence, specific surface area and bjh pore size distribution, ft-ir spectroscopy, scanning electron micro...

Nano-MgO was successfully deposited on titania using deposition-precipitation method. The catalyst produced was characterised using FTIR, XRD, BET and XRF and its activity was tested on the transesterification reaction of soybean oil to biodiesel. The catalyst activity improved when the reaction temperature was increasedfrom 150 and 225 C. It was also observed that increasing the reaction time ...

How graphene oxide (GO) with its step edges and wrinkles (∼1-2 nm) acts as a catalyst in hydrothermal nucleation and growth is demonstrated. TiO2 whiskers were prepared by using GO as a support, while TiO2 nanograss was prepared without using GO.

This study demonstrates the synthesis of TiO2 nanobelts using solution combustion derived TiO2 with enhanced photocatalytic activity for dye degradation and bacterial inactivation. Hydrothermal treatment of combustion synthesized TiO2 resulted in unique partially etched TiO2 nanobelts and Ag3PO4 was decorated using the co-precipitation method. The catalyst particles were characterized using X-r...

BACKGROUND Anomalous use of antibiotics and their entrance into the environment have increased concerns around the world. These compounds enter the environment through an incomplete metabolism and a considerable amount of them cannot be removed using conventional wastewater treatment. Therefore, the main objectives of this research are evaluation of the feasibility of using ultraviolet radiatio...

Increasing the activity of a photocatalyst goes through the improvement of both its absorption (light) and adsorption (reactant) properties. For a given semiconducting material, the charge carrier separation is also a very important step. Properly combining chosen phases is one option to improve this separation (example of the commercial P25) and depositing platinum on the surface of the cataly...

Ag-based catalysts with different supports (TiO2, Al2O3 and CeO2) were prepared by impregnation method and subsequently tested for the catalytic oxidation of formaldehyde (HCHO) at low temperature. The Ag/TiO2 catalyst showed the distinctive catalytic performance, achieving the complete HCHO conversion at around 95 °C. In contrast, the Ag/Al2O3 and Ag/CeO2 catalysts displayed much lower activit...

In an Al2O3-TiO2 mixed oxide system, the incorporation of TiO2 to alumina is known to increase the acidity of the resulting mixed oxide; depending strongly on the preparation method and the titania concentration. When using TiO2 as a support of NiMo catalysts, initial catalytic activity in hydrodesulfurization reactions is much higher than that on catalysts based on pure alumina. One of the mai...

Solar light induced interfacial charge transfer of electrons from TiO2 to CuO in a water-glycerol mixture produced 99,823 μmol h(-1) g(-1)catalyst of hydrogen gas. The dispersed CuO/TiO2 photocatalyst in solution exhibited uni-directional electron flow and capture at the Schottky barrier facilitating charge separation and electron transfer resulting in enhanced H2 production performance.

Introduction One-pot oxidation reaction consisted of direct synthesis of hydrogen peroxide (H2O2) from H2 and O2 gases and oxidation reaction using in situ generated H2O2 is promising synthetic method, because it is possible to use the unstable H2O2 immediately without isolation/purification steps, which would contribute to energy and time saving as well as avoid the risk of transportation of t...