this paper aims at investigating the influence of partial replacement of portland cement with ultrafine fillers compared to limestone powder on the durability and mechanical characteristics of concrete. for this purpose, ultrafine calcium carbonate materials with different specific surface areas of 9.7 and 15.1 m2/g and limestone powder (0.72 m2/g) were used. the results indicate that the ultra...

Examination of a time–temperature–transformation (TTT) diagram for an eutectoid carbon steel (Fig. 1), bearing in mind the fact that the pearlite reaction is essentially a high temperature one occurring between 550C and 720C and that the formation of the martensite is a low-temperature reaction, reveals that there is a wide range of temperature ∼250–550C within which neither of these phases for...

Bainite has been obtained by heat treatment at temperatures as low as 125°C in a high carbon, high silicon steel. This has had the effect of greatly re® ning the microstructure, which is found to have a strength in excess of 2.5 GPa together with an ability to ̄ ow plastically before fracture. Such properties have never before been achieved with bainite. In this paper metallographic details are ...

ABSRACT A comparative study of the surface microstructural changes after fatigue in an ultrafine grained and coarse grained aluminum alloy was performed using orientation imaging microscopy (OIM). The fraction of low angle boundaries with misorientation less than 2.5 ̊ increased for both the coarse and ultrafine grained alloys. A consistent decrease in the fraction of low angle boundaries, with ...

The monotonic and cyclic deformation behavior of ultrafine-grained metastable austenitic steel AISI 304L, produced by severe plastic deformation, was investigated. Under monotonic loading, the martensitic phase transformation in the ultrafine-grained state is strongly favored. Under cyclic loading, the martensitic transformation behavior is similar to the coarse-grained condition, but the cycli...

The tandem differential mobility analyzer (TDMA) technique was applied to determine the hygroscopicity and volatility of atmospheric ultrafine particles in three sites of urban Gwangju, industrial Yeosu, and coastal Taean in South Korea. A database for the hygroscopicity and volatility of the known compositions and sizes of the laboratory-generated particles wasfirst constructed for comparison ...

Microstructure and properties have been studied for high strength steel weld metals with variations in carbon, manganese and nickel. Based on neural network modelling, experimental welds were made using shielded metal arc welding with manganese at 0.5 or 2.0 wt. % and nickel at 7 or 9 wt. %. Additional welds were made where carbon was varied between 0.03 and 0.11 wt. %. Generally there was very...

A theory is developed for the evolution of bainite as a function of time, temperature, chemical composition and austenite grain size. The model takes into account the details of the mechanism of transformation, including the fact that nucleation begins at the austenite grain surfaces, and that the growth of a sheaf occurs by the repeated nucleation of small platelets. Predictions made using the...

There is a novel steel invented in which the structure consists of extremely fine platelets of bainitic ferrite dispersed in a matrix of carbon enriched retained austenite. The resulting large density of interfaces makes the alloy very strong in its transformed condition. The authors report the first fatigue tests on this system, by measuring the life of parallel gauged samples tested using cyc...