This paper presents parts of the results from a research project sponsored by Taiwan Environmental Protection Administration (TEPA), investigating both the physical and environmental properties of asphalt mixtures using different amount of incinerator bottom ash (IBA) as fine aggregate substitution. The Marshall mix design method was used to determine the design asphalt content and evaluate the...

The National Institute for Occupational Safety and Health (NIOSH) has a partnership relationship with the asphalt paving and roofing industries and their associated unions. Our partners saw in the EHP Focus article “Paving Paradise: The Peril of Impervious Surfaces” (Frazer 2005) the statement on page A459: “Asphalt is one concern, as it contains coal tar pitch, a recognized human carcinogen .....

Concrete track slab and asphalt trackbed are being introduced in Korea for providing good bearing capacity, durability to the track and comfortable rideness to passengers. Such a railway system has been designed by the train load so as to ensure stability. But there is lack of research and design for temperature changes which influence the behavior characteristics of concrete and asphalt. There...

Asphalt road reflectance spectra change as pavement ages. This provides the possibility for remote sensing to be used to monitor a change in asphalt pavement conditions. However, the relatively narrow geometry of roads and the relatively coarse spatial resolution of remotely sensed imagery result in mixtures between pavement and adjacent landcovers (e.g., vegetation, buildings, and soil), incre...

In this paper, annoyance ratings from traffic noise recorded on cobblestones, dense asphalt, and open asphalt rubber pavements are assessed with regard to car speeds and traffic densities. It was found that cobblestones pavements are the most annoying; also while open asphalt rubber pavement imposes less annoyance than dense asphalt it is not significantly different. Higher car speeds always le...

In addition to lower emissions warm mix asphalt has several advantages over hot mix asphalt such as fuel energy savings, decreased binder aging and an extended paving season (Photo courtesy: Matthew Corrigan, FHWA) The National Center for Asphalt Technology (NCAT) is evaluating warm mix asphalt (WMA) technologies. WMA technology allows the mixing, lay down, and compaction of asphalt mixes at si...

Asphalt pavement itself is a mixture made up of mainly aggregates, binders, and fillers that acts as a composition used for pavement construction. An experimental program was setup to determine the fatigue performance test of Asphalt with three different grades of conventional binders. Asphalt specimen has achieved the maximum optimum bulk density and air voids with a consistent bulk density of...

Conventional asphalt binder derived from the petroleum refining process is widely used in pavement engineering. However, asphalt binder is a non-renewable material. Therefore, the use of a co-production of renewable bio-oil as a modifier for petroleum asphalt has recently been getting more attention in the pavement field due to its renewability and its optimization for conventional petroleum-ba...

Adhesion between asphalt and aggregate plays an important role in the performance of asphalt mixtures. A low-frequency adhesion fatigue test was proposed in this paper to study the effect of environment on the asphalt-aggregate adhesion system. The stress-based fatigue model had been utilized to describe the fatigue behavior of thin-film asphalt and aggregate system. The factors influencing the...

Asphalt pavements undergo long-term aging due to oxidation of the asphalt binder. As a pavement oxidizes, it stiffens and eventually cracks. The use of an antioxidant in an asphalt binder could retard aging, thus increasing the pavement’s service life. Lignin is a known antioxidant and is highly available from timber and many agricultural products. A wet-mill ethanol process produces several co...