This proposal proposes a DC/DC Buck Boost converter which has been used as a smooth starter for a DC Permanent Magnet Motor. In the existing system the DC/DC Buck Converter is used which provide the output less than the input Signal. Using buck converter it is difficult to increase the value of the input signal. Hence DC/DC BuckBoost Converter used from which it is possible to get both the incr...

This paper describes an investigation into the development of a new generation of threephase rectifier, used to power telecommunications equipment. Traditionally, the topology used is a single-phase two-stage design, with a boost converter at the input to the first stage and an isolated dcdc converter making up the second stage. The boost converter provides power factor correction which is nece...

Energy-efficient, linear RF power amplifiers (PAs) are critical for achieving longer battery life in state-of-the-art radio transceivers because typically they determine and dominate the power consumption of the system. In this paper, an adaptive power management scheme using a novel dual-mode, noninverting, buck-boost converter targeted for code-division-multiple-access (CDMA) RF PA is present...

Solid-state switch-mode rectification converters have reached a matured level for improving power quality in terms of power-factor correction (PFC), reduced total harmonic distortion at input ac mains and precisely regulated dc output in buck, boost, buck–boost and multilevel modes with unidirectional and bidirectional power flow. In this paper, an improved power quality converter employing con...

The paper presents a new methodology for optimizing the design of DC-DC converters. The magnitudes that we take into account are efficiency, ripples, bandwidth, and RHP zero placement. We apply a geometric programming approach, because the variables are positives and the constraints can be expressed in a posynomial form. This approach has all the advantages of convex optimization. We apply the ...

Renewable energy sources are being widely used for Distributed Generation (fuel cells, solar panels, Wind power generators etc..,) because of their advantages. But they produce a very low output voltage. To interconnect a low-dc-voltage to residential loads a special voltage matching converter is required. This paper presents a back to back connection of cascaded quasi-Z-source network based st...

Due to ready availability of resources, there is a vast spike in the growth of sustainable power sources. Among them solar photovoltaic (PV) world power technique is presently careful, being an of great magnitude substitute influence supplier, for the reason that of the set availability of eminent able PV panels with the aim of eliminate the depressing environmental aspects. Low voltage PV syst...

A unified approach is suggested for the derivation of current-tocurrent converter topologies, which relies on duality principles. As conventional duality rules have restricted utility and are difficult to apply with switched mode circuits, special attention is devoted to switch mode converter element dualities. Also, a special means of viewing complex switched mode topologies as a cascade combi...

This study presents a novel Switched Reluctance Motor (SRM) drive system with power factor improvement. Recently, many of the converters with variable speed drives have no input power factor correction circuits. This results in harmonic pollution of the utility supply, which should be avoided. The effect of power factor variation in terms of harmonic content is also analyzed in this study. The ...

Fuel cells are new alternative energy resource that has a great promise for distributed generation and electric vehicle application. However, fuel cells have a slow response due to their slow internal electromechanical and thermodynamic response. To optimize the fuel cell system performance, a fuel cell DC-DC converter with an appropriate controller which can regulate the power flow and automat...