Pearlitic steels present very interesting mechanical properties when weldability requirements are not too severe. Thin gauge pearlitic steels require at least one intermediate annealing treatment between hot rolling and cold rolling. The globularised cementite in medium carbon steels provides then higher ductility, formability and machinability. On the other hand, in-line induction heating devi...

The effects of carbon content on the dynamic and static softening mechanisms of Ti microalloy steels were investigated both in ferrite and austenite regions. The results obtained showed that recrystallization rate decreased as the percentage of carbon content was increased from 0.0035 to 0.110. This is due to the Ti(CN) and TiC precipitates and also the free carbon content. In the ferrite reg...

A systematic study of the influence of plastic deformation and low temperature ageing on the carbon Dislocation Enhanced Finkelshtain Rosin Effect (DEFREIC) in austenitic alloys of Fe-Ni, Fe-Ni-MO, Fe-Mn-A1 and Fe-Cr-Ni systems with different carbon content is reported. The experiments prove that after plastic deformation at room temperature the FR effect is transformed into DEFREIC. nith both ...

Structural steels with very high strength levels are often referred to as ultrahigh-strength steels (UHSS). The usage of UHSS has been extensively studied in aerospace industries and offshore platforms. In this study, medium carbon low alloy steel (AMS6305) was thermomechanicaly treated to obtain an ultra-high strength bainitic steel for aircraft engine compressor disk. A novel themomechanical ...

This paper reports on the precipitation behaviour and microstructural evolution in ~20% cold rolled NbMoV and V single microalloyed low carbon steels during intercritical annealing. The microstructure and precipitation behaviour were studied by optical and scanning/transmission electron microscopy and microanalysis, X-ray diffraction technique and Vickers hardness testing. After intercritical a...

In most of the engineering applications, such as mining, metallurgy, agriculture; equipments are failed by the abrasive wear. The data as obtained form ministry of Research and Technology indicates that the percentage cost of abrasive wear in federal republic of German in metallurgy industry is 40%, mining industry 30%, agriculture 20% and production engineering 10%, and so the material selecti...

The influence of the surface mechanical-pulse treatment based on high-speed friction with a rapid cooling by the technological environment on the wear resistance of medium- and high-carbon steels was considered. The treatment due to a severe plastic deformation enabled obtaining the nanocrystalline structure with a grain size of 14-40 nm. A high positive effect of this treatment was obtained no...