In this paper, the corrosion behavior of the filled epoxy paint with the rice husk ash RHA on steel substrates in two different corrosive environments natural sea water and 2M sulfuric acid has been studied. Electrochemical impedance spectroscopy EIS was used to evaluate protective properties of different organic coating systems due to the different filler composition. RHA was prepared by heati...

A highly dense Ni59Zr20Ti16Si2Sn3 partial amorphous metallic coating, about 500mm thick, was fabricated by means of HVAF (High Velocity Air Fuel) thermal spraying. Amorphous alloy powders produced by using gas atomization were used for HVAF thermal spraying to produce an amorphous metallic coating. Microstructural investigation showed that crystallization and oxidation occurred during thermal s...

Titanium is a key biomedical material due to its good biocompatibility, mechanical properties and corrosion stability, but infections at the implantation site still pose a serious threat. One approach to prevent infection is to improve the antimicrobial ability of the coating material. Silver-doped hydroxyapatite (Ag/HAP) nanoparticles were synthesized by a new modified precipitation method. Th...

MCrAlY coatings (M=Ni and/or Co) have been widely used for the protection of superalloy components against oxidation and hot corrosion in the hot sections of gas turbines. The drive to improve engine combustion efficiency while reducing emissions by increasing the operation temperature brings a big challenge for coating design. As a result, the need for improvement of MCrAlY coatings for better...

An attempt has been taken to improve the corrosion resistance of twinning-induced plasticity (TWIP) steels (Fe-25Mn and Fe-25Mn-3Al) by electroless Ni-P coating. Corrosion resistance in 3.5% NaCl and 0.1M H2SO4 solutions was characterized by the potentiodynamic polarization curves and Tafel method calculations. It was found that Ni-P coating improved the corrosion resistance by the factor of 4 ...

Potentiodynamic polarization and impedance tests were carried out on 316L stainless steel with culturing murine fibroblast L929 cells to elucidate the corrosion behaviour of 316L steel with L929 cells and to understand the electrochemical interface between 316L steel and cells, respectively. Potential step test was carried out on 316L steel with type I collagen coating and culturing L929 cells ...

This paper reviews the available literature relating to the emerging research into the performance of coatings under combined wear and corrosion conditions. Understanding how coatings perform under these tribo-corrosion conditions is essential if the service life of equipment is to be predicted and to allow service life to be extended. Therefore, the tribo-corrosion performance of coatings depo...

Due to their unique biodegradability, magnesium alloys have been recognized as suitable metallic implant materials for degradable bone implants and bioresorbable cardiovascular stents. However, the extremely high degradation rate of magnesium alloys in physiological environment has restricted its practical application. This paper reports the use of a novel microwave assisted coating technology ...

Tightly bonding of bioactive coating is the first crucial need for orthopaedic implants. This study describes a novel and convenient technique to prepare bioactive coating with high adhesion on orthopaedic substitutes made of polymeric matrix. Here, a chemical corrosion method has been adopted to fabricate a coating on the surface of injection-moulded polyamide66 (PA66) substrates by corrosive ...

OBJECTIVE To analyze the effect of various coating formulations on the mechanical and corrosion properties of nickel-titanium (NiTi) orthodontic wires. MATERIALS AND METHODS Uncoated, rhodium-coated, and nitrified NiTi wires were observed with a three-point-bend test, surface roughness (Ra) measurement, scanning electron microscopy, energy dispersive spectroscopy, and electrochemical testing ...