By using a quadratic compensation slope, a CMOS current-mode buck DC-DC converter with constant frequency characteristics over wide input and output voltage ranges has been developed. The use of a quadratic slope instead of a conventional linear slope makes both the damping factor in the transfer function and the frequency bandwidth of the current feedback loop independent of the converter’s ou...

This paper presents an electric drive system whose motor is connected to a battery by means of a buck DC/DC converter. This motor is further connected to an ultracapacitor by means of a boost DC/DC converter. First, operation and break processes are studied when the converters are switched off as well as when they are switched on in current limitation mode. Then, a comparative analysis of the r...

This project is a highly efficient and novel control strategy for improving the transients in the output voltage of a dc–dc positive buck–boost converter which is required for low-power portable electronic applications. The proposed control technique can regulate the output voltage for variable input voltage (higher, lower, or equal to the output voltage). There are several existing solutions t...

D1 D2 S2 Abstract—This paper proposes two types of non-isolated direct AC-DC converters. First, it shows a buck-boost converter with an H-bridge, which requires few components (three switches, two diodes, one inductor and one capacitor) to convert AC input to DC output directly. This circuit can handle a wide range of output voltage. Second, a direct AC-DC buck converter is proposed for lower o...

in this paper, a novel approach for control of the dc-dc buck converter in high-power and low-voltage applications is proposed. designed method is developed according to state feedback linearization based controller , which is able to stabilize output voltage in a wide range of operation. it is clear that in high-power applications, parasitic elements of the converter may become comparable with...

In this paper, a non isolated multi-input multi-output dc–dc boost converter is proposed. This converter is used to implant alternative energy sources in electric vehicles. However, advantages of different sources of energy are achievable by the implant energy sources. This converter has many outputs with different voltage levels, which can be interfaced with multilevel inverters. In this conve...

ISSN: 2319-1112 /V2N2:243-248 ©IJAEEE Abstract : To increase the processing speed and decrease the power consumption, the operating voltages of computer microprocessors is reduced below 1.5V. At the same time, it is expected that these processors will require much more current. To keep the distribution losses low at an increased power level, the input current of the new generation of on-board d...

A DC-to-DC converter for applications involving a source with widely varying voltage conditions with loads requiring constant voltage from full load down to no load is presented. The switching regulator considered is a Buck converter with Pulse Skipping Modulation control whereby pulses applied to the switch are blocked or released on output voltage crossing a predetermined value. Results of th...