نتایج جستجو برای: drilling process
تعداد نتایج: 1323028 فیلتر نتایج به سال:
numerous parameters influence bit selection process, which considering all them is not normally feasible. existing methods use limited number of these parameters to choose a suitable bit for a specific drilling condition. one of the widely used methods is cost per foot. specific energy and drilling strength are another methods currently used for bit selection. different methods of bit selection...
This research outlines the Taguchi optimization methodology, which is applied to optimize cutting parameters in drilling of glass fiber reinforced composite (GFRC) material. Analysis of variance (ANOVA) is used to study the effect of process parameters on machining process. This procedure eliminates the need for repeated experiments, time and conserves the material by the conventional procedure...
Determining the optimum input parameter settings (temperature, rotational velocity and feed rate) in optimizing the properties (strength and time) of the nano-drilling process can result in an improvement in its environmental performance. This is because the rotational velocity is an essential component of power consumption during drilling and therefore by determining its appropriate value requ...
in the present study, five modeling approaches of ra, mlp, mnn, gff, and canfis were applied so as to estimate the radial overcut values in electrochemical drilling process. for these models, four input variables, namely electrolyte concentration, voltage, initial machining gap, and tool feed rate, were selected. the developed models were evaluated in terms of their prediction capability with m...
PURPOSE It is essential to have sufficient bone bulk and density at the implant site in order to achieve good bone-to-implant contact and primary stability, which are crucial for osseointegration. A new osteotomy preparation technique was recently introduced that uses a bone preservation method that creates a layer of compacted bone along the surface of the osteotomy. The hypothesis of this stu...
The microwave-drilling technique using an open-end coaxial applicator was disclosed recently [1-3]. This paper presents new experimental and theoretical results of microwave-drilling studies in various ceramics, including mullite, alumina, and zirconia. The paper reviews the microwave-drill principles and describes the experimental setup and procedures. Aspects of igniting the microwavedrilling...
نمودار تعداد نتایج جستجو در هر سال
با کلیک روی نمودار نتایج را به سال انتشار فیلتر کنید