introduction: periodontal diseases are considered as some of the most common reasons of teeth loss, which occur due to the aggregation of microbial plaque and other precipitations on the dental surfaces . in this study, the scaling effect using manual tools, ultrasonic machine and erbium-doped yttrium aluminum garnet (er:yag)laser on the connection of the human gums connective tissue cells on t...

of a range of eye problems with little risk of infection. Many laser procedures are relatively pain free and can be performed on an outpatient basis. The combination of safety, accuracy, and relative low cost make lasers very useful ophthalmic tools. The word laser is an acronym for ‘light amplifi cation by stimulated emission of radiation’. Laser light is coherent (the waves are in phase in sp...

Er-YAG laser irradiation has been claimed to improve the adhesive properties of dentin. We tested the hypothesis that dentin adhesion is affected by Er-YAG laser conditioning. Superficial or deep dentin from human molars was: (a) acid-etched with 35% H3PO4; (b) irradiated with an Er-YAG laser (KaVo) at 2 Hz and 180 mJ, with water-cooling; and (c) laser- and acid-etched. Single Bond (3M ESPE) an...

This paper introduces a deposition method to create a multilayered waveguide with alternating layers of high index of refraction contrast. A very thin Ag layer, practically transparent in the mid-IR radiation wavelengths of CO(2) and Er-YAG lasers, was created. This enabled a good contrast of the indices of refraction of silver/silver iodide. Theoretical calculations as well as experiments have...

o bjectives: bond strength of composite resin to enamel and dentin of primary teeth is lower than that to permanent teeth; therefore, it may compromise the ad- hesive bonding. new methods, such as laser application have been recently intro- duced for tooth preparation. the purpose of this study was to evaluate the effect of tooth preparation with bur and er:yag laser on shear bond strength of c...

Single-crystal (SC) fibers have the potential of delivering extremely high laser energies. Sapphire fibers have been the most commonly studied SC fiber and the losses for sapphire fibers have been as low as 0.4 dB/m for a 300micron core-only fiber at 3 microns. In this study we report on the growth of SC yttrium aluminum garnet, Y3Al5O12 (YAG) fibers from undoped SC source rods using the Laser ...

Background and aims: Skin rejuvenation is one of high demand cosmetic interventions in Iran. Fractional CO2 Laser is a high power ablative laser which has variety of utilization in medicine including treatment of acne scars and rejuvenation. The aim of this study was to evaluate the safety, efficacy, and cost-effectiveness of Fractional CO2 Laser in comparison with other methods of rejuvenation...

Introduction The Thulium fiber laser (TFL) is a new device that in contrast to the other solid-state YAG-based lasers takes different approach pulse formation allowing for two modes: QCW (quasi-continuous wave) function, TFL convenient soft tissue surgery and SP (Superpulsed) mode it highly effective lithotripsy. Thus, unlike thulium (Tm : YAG), can be used wide range of surgical procedures. Ma...

Single-crystal rare-earth doped YAG fiber lasers grown by the laser-heated pedestal growth technique Report Title High concentrations of the rare-earth elements erbium, holmium and thulium have been successfully doped into single crystal (SC) yttrium aluminum garnet (YAG, Y3Al5O12) fibers by use of the laser heated pedestal growth (LHPG) method. The spontaneous emission spectra and fluorescence...