In the present study, Adaptive Neuro–Fuzzy Inference System (ANFIS) approach was applied for predicting the heat transfer and air flow pressure drop on flat and discontinuous fins. The heat transfer and friction characteristics were experimentally investigated in four flat and discontinuous fins with different geometric parameters including; fin length (r), fin interruption (s), fin pitch (p), ...

This paper provides a review on the fouling mechanism and its effect onto the performance of finned tube heat exchangers in HVAC systems. Fouling tends to degrade the performance of heat exchangers by decreasing the heat transfer coefficient and increasing the air-side pressure drop across the heat exchangers. Air side fouling depends on a number of factors on the air side, including type and c...

Designs of heat exchangers have mostly been disconnected to the performance of thermoelectric generator (TEG) systems. The development work, mostly focused on thermoelectric materials, required a significant amount of engineering parametric analysis. In this work, a micro plate-fin heat exchanger applied to a TEG is investigated and optimized to maximize the output power and the cost performanc...

In this paper, Adomian decomposition sumudu transform method is introduced and used to solve the temperature distribution in a solid and porous fin with the temperature dependent internal heat generation for a fractional order energy balance equation. In this study, we assume heat generation as a variable of fin temperature for solid and porous fin and the heat transfer through porous media is ...

Studies using commercial computational fluid dynamics software, running on a supercomputer, were carried out to investigate the effects of fin density, inlet duct velocity, and clearance area ratio, on the extent of flow bypass and its impact on the thermal performance of the heat sink. Flow bypass was found to increase with increasing fin density and clearance, while remaining relatively insen...

The condensation heat transfer coefficient of R134a was experimentally studied inside two smooth and four micro-fin tubes. The working conditions and structural parameters of the test tubes were selected as the influencing factors, and the experiment was conducted under mass velocities of 400–1100 kg·m−2·s−1, condensation temperatures of 35–45 ◦C and water-testing Reynolds numbers of 8000–22,00...

Steady heat transfer through a pin fin is studied. Thermal conductivity, heat transfer coefficient, and the source or sink term are assumed to be temperature dependent. In the model considered, the source or sink term is given as an arbitrary function. We employ symmetry techniques to determine forms of the source or sink term for which the extra Lie point symmetries are admitted. Method of sep...

In most domestic and commercial refrigeration systems, frost forms on the air-side surface of the air-to-refrigerant heat exchanger. Frost-tolerant designs typically employ a large fin spacing in order to delay the need for a defrost cycle. Unfortunately, this approach does not allow for a very high air-side heat transfer coefficient, and the performance of these heat exchangers is often air-si...

Engine life and effectiveness can be improved with effective cooling. The cooling mechanism of the air cooled engine is mostly dependent on the fin design of the cylinder head and block. The heat is conducted through the engine parts and convected to air through the surfaces of the fins. Insufficient removal of heat from engine will lead to high thermal stresses and lower engine efficiency. As ...

Direct numerical simulations of unsteady natural convection in a differentially heated cavity with a thin fin of different lengths on a sidewall at the Raleigh number of 3.8 × 10 are performed. It is found that the fin length significantly impacts on the transient thermal flow around the fin and heat transfer through the finned sidewall in the early stage of the transient flow development. The ...