In order to carry out experimental investigations on radial inflow gas turbine, a special test laboratory was designed and constructed at Sharif University of Technology. This laboratory is introduced in the present paper and experimental procedures are elaborated on. Then, some test results are presented and discussed. The trends of performance characterisitics match our expectation and show g...

The article contains the results of validation of the numerical computational models of the uncooled turbines of gas turbine plants created in the software suite NUMECA. The findings of the study of impact of the computational mesh dimension, account of the pre-path cavities on the design characteristics of turbines by modeling are represented in this article. As a result, there have been devel...

Power generation using gas turbine power plants operating on the Brayton cycle suffers from low efficiencies. In this work, a solid oxide fuel cell (SOFC) is proposed for integration into a 10 MW gas turbine power plant, operating at 30% efficiency. The SOFC system utilizes four heat exchangers for heat recovery from both the turbine outlet and the fuel cell outlet to ensure a sufficiently high...

A new mechanism responsible for structural life consumption due to resonant fatigue in turbine blades, or vanes, is presented and explained. A rotating blade or vane in a gas turbine can change its contour due to erosion and/or material build up, in any of these instances, the surface pressure distribution occurring on the suction and pressure sides of blades-vanes can suffer substantial modifi...

Helium gas turbine is the key component of the power conversion system for direct cycle High Temperature Gascooled Reactors (HTGR), of which an optimal design is essential for high efficiency. Gas turbine design currently is a multidisciplinary process in which the relationships between constraints, objective functions and variables are very noisy. Due to the ever-increasing complexity of the p...

The aeroderivate gas turbines are widely used for power generation in the oil and gas industry. In offshore marine platforms, the aeroderivative gas turbines provide the energy required to drive mechanically compressors, pumps and electric generators. Therefore, the study of the performance of aeroderivate gas turbines based on a parametric analysis is relevant to carry out a diagnostic of the ...

Cooling characteristics are given in terms of the variation of average blade temperature at mid-span with cooling-flow rate, Reynolds number, gas/cooling-air absolute temperature ratio, and, for the rotor, gas-stream incidence. Chordwise and spanwise variations of blade temperature are also presented. Measured pressure-drop characteristics indicate that in a gas-turbine engine, with the cooling...

A design point simulation and adaptation of anindustrial GE LM2500+ gas turbine engine is presented. The design point is chosen when the engine runs steadily at operating point and close to the nominal design condition at 29MW power output. The targeted performance parameters are the fuel flow rate (FF), the compressor exit total pressure (P3), the compressor turbine total exit temperature (T8)...