Power system is a combination of a number of sources and loads properly linked by a transmission system. The source is a generating system fueled by renewable or non renewable system where bio mass fuel is used to generate electric power. Due to low levels of bio fuel availability, the gas turbine system is considered as a weak system when compared to thermal and hydro systems. However, stable ...

The purpose of introducing a combined cycle with gas turbine in power plants is to reduce losses of energy, by effectively using exhaust gases from the gas turbine to produce additional electricity or process. The efficiency of a combined power plant with the gas turbine increases, exceeding 50%, while the efficiency of traditional steam turbine plants is approximately 35% to 40%. Up to the pre...

Development of robust and highly sensitive algorithms for detecting incipient bearing faults in gas turbine engines will greatly benefit both military and civil aviation through improved aircraft reliability and maintainability. Techniques including advanced vibration analysis and oil debris monitoring have proven effective in laboratory and industrial settings, but factors including poor trans...

At Stora Enso Fine Paper Nymölla Mill there is a wish to reduce its dependency on external produced electric power. One suggestion that has been made is to install a hot air gas turbine. The purpose of this thesis is to see if it is thermodynamic and economical to go through with the project with the hot air gas turbine. It is of great importance that the boiler-process remains as unchanged as ...

The gas-steam turbine combined cycle (GTCC) is the preferred power plant type because of its high efficiency and its use of cheap and clean natural gas as fuel. It is also the preferred type in the Arab Gulf countries where it is used as cogeneration power-desalting plant (CPDP). In this chapter, descriptions and analysis of the GTCC components are presented, namely, the gas turbine cycle (comp...

In this paper, we propose an approach to generating summaries of time series data in the gas turbine domain using AI techniques. Through the think-aloud method with the aid of visualization of temporal data using time series workbench (TSW), both domain knowledge from experts about how to solve problems in the gas turbine and information about how domain experts analyze the archived temporal da...

Wind power has expanded significantly over the past years, although reliability of wind turbine systems, especially of offshore wind turbines, has been many times unsatisfactory in the past. Wind turbine failures are equivalent to crucial financial losses. Therefore, creating and applying strategies that improve the reliability of their components is important for a successful implementation of...

The National Renewable Energy Laboratory presented an investigation of various wind turbine drivetrain condition monitoring (CM) techniques at the 7 International Workshop on Structural Health Monitoring held in 2009. The study contained in this report is a continuation of the 2009 paper and focuses on results obtained by various CM techniques from a damaged Gearbox Reliability Collaborative te...

A permanent magnet synchronous generator (PMSG) variable speed wind turbine connected to an electrolyzer and a battery model system is presented in this paper. Hydrogen gas could be produced from the model system, when a variable wind speed is applied to the PMSG driven variable wind turbine. The simulation results presented shows the nature of some of the variables of the PMSG wind driven turb...