It is well known that plastic deformation induced by conventional forming methods such as rolling, drawing or extrusion can significantly increase the strength of metals However, this increase is usually accompanied by a loss of ductility. For example, Fig. 1 shows that with increasing plastic deformation, the yield strength of Cu and Al monotonically increases while their elongation to failure...

Towards electroformed nanostructured aluminum alloys with high strength and ductility. Article is made available in accordance with the publisher's policy and may be subject to US copyright law. Please refer to the publisher's site for terms of use. The MIT Faculty has made this article openly available. Please share how this access benefits you. Your story matters. Nanostructured Al–Mn alloys ...

By Timothy Phillips Vaughan, MS. Washington State University May 2010 Chair: David I. McLean This research evaluated the structural performance of reinforced masonry shear walls conforming to requirements given in the 2008 MSJC Building Code Requirements for Masonry Structures under cyclic lateral loading. Seismic design provisions in the 2008 MSJC provide prescriptive requirements for three di...

The use of industrial by-products of the vegetable oil industry as ductility increasing additives of polylactide (PLA) was investigated. Vegetable oil deodorization condensates were melt-blended by twin-screw extrusion up to a maximum inclusion quantity of 20 wt% without preliminary purification. Sample films were obtained by single screw cast extrusion. Compounded PLA films featured largely im...

In this paper, moment-curvature behavior and ductility of prestressed concrete members based on nonlinear analysis is investigated. Influence of various design parameters on ductility of flexural members is determined according to appropriate materials models for stress-strain curves of concrete, prestressing steel and conventional reinforcements. Parameters studied include reinforcing index (ω...

According to standards, the durability performance of fiber-cement sheets must be evaluated by comparing the modulus of rupture (MOR) before and after durability tests (freeze-thaw, soak-dry, and warm water) are completed. This paper investigated the MOR of two different fiber-cement sheets samples before and after durability tests as well as its ductility and toughness. Results showed no signi...

It is known that the room-temperature plastic deformation of bulk metallic glasses is compromised by strain softening and shear localization, resulting in near-zero tensile ductility. The incorporation of metallic glasses into engineering materials, therefore, is often accompanied by complete brittleness or an apparent loss of useful tensile ductility. Here we report the observation of an excep...

Friction stir processing (FSP) 2519-T87 aluminum plate results in enhanced ductility, 25% strain at fracture. However, the yield strength in the FSP zone drops to 175 MPa from �400 MPa. Actively cooling the plate during FSP increases the yield strength to 185 MPa and decreases ductility to 20% strain at fracture. Thick bending of a plate of the alloy was demonstrated after the surface was subje...

Abstract: The primary aim of the project was to explore the possibility of synthesising high strength multiphase eutectic alloys based on aluminium which also exhibits reasonable ductility. The approach used was to develop a multiscale microstructure including nanometer length scale eutectic colony using ternary alloys and evaluate their deformation behaviour. We have carried out work on two al...

Metallic nanowires usually exhibit ultrahigh strength but low tensile ductility owing to their limited strain hardening capability. Here we study the unique strain hardening behavior of the five-fold twinned Ag nanowires by nanomechanical testing and atomistic modeling. In situ tensile tests within a scanning electron microscope revealed strong strain hardening behavior of the five-fold twinned...