The hot deformation and dynamic recrystallization behavior of the dual-phase Mg-9Li-3Al-2Sr-2Y alloy had been investigated using a compression test. The typical dual-phase structure was observed, and average of grain size of as-homogenized alloy is about 110 µm. It mainly contains β-Li, α-Mg, Al₄Sr and Al₂Y phases. The dynamic recrystallization (DRX) kinetic was established based on an Avrami t...

We use confocal microscopy and time-resolved light scattering to investigate plasticity in a colloidal polycrystal, following the evolution of the network of grain boundaries as the sample is submitted to thousands of shear deformation cycles. The grain boundary motion is found to be ballistic, with a velocity distribution function exhibiting nontrivial power law tails. The shear-induced dynami...

The amount of twin formation of electroplated and thermally treated copper thin films was evaluated by electron back-scattering diffraction (EBSD) analysis. The result establishes the importance of twin formation in the analysis of stress-induced voiding, and indicates that with the inclusion of a copper alloy co-element, twin formation was significantly reduced relative to pure-copper. Further...

Two-phase bimetal composites contain both grain boundaries and bi-phase interfaces between dissimilar crystals. In this work, we use a crystal plasticity finite element framework to explore the effects of grain boundary interactions on the plastic stability of bi-phase interfaces. We show that neighboring grain interactions do not significantly alter interface plastic stability during plane str...

due to the great variety of applications of magnesium alloys with superior mechanical properties, recent studies have been focused on the hot deformation behavior and microstructure of magnesium alloy castings. although there have been several recent investigations on the microstructure of wrought magnesium alloys after hot deformation, a limited number of studies have been conducted with regar...

This paper presents novel advances in the deformation behaviour of polycrystalline and single crystal silicon using molecular dynamics (MD) simulation and validation of the same via nanoindentation experiments. In order to unravel the mechanism of deformation, four simulations were performed: indentation of a polycrystalline silicon substrate with a (i) Berkovich pyramidal and a (ii) spherical ...

effect of small al additions, from 0.14% to 0.31% ai, on the hot deformation behavior of low carbon steels containing 1%cu-1.2%mn was investigated in the temperature range of 750-800•c over the strain rate range of 1o.3.1o.1s•1 by a hot compression testing machine. the flow curves obtained, exhibited typical characteristics of dynamic recovery type of softening mechanism, and the critical strai...

0167-9317/$ see front matter 2010 Elsevier B.V. A doi:10.1016/j.mee.2010.04.019 * Corresponding author. E-mail address: [email protected] (V. Sriram). We have performed in-situ nanocompression testing in a transmission electron microscope (TEM) of copper pillars having dimensions of the same order of typical via and line structures used in the semiconductor industry. We show direct evidence that...

Abstract: The viscoplastic deformation of ice is strongly anisotropic. The preferred glide system is on the basal plane. In a polycrystal each grain exhibits its own deformation direction. As a result the deformation of polycrystalline ice is associated with strain incompatibilities, especially at the grain boundaries and the triple junction. The deformation process was experimentally investiga...

the study of nucleation mechanism of new grains during severe plastic deformation of magnesium alloys is of great importance to control the characteristics of final microstructures.  to investigate the role of discontinuous recrystallization, a wrought az31 magnesium alloy was deformed by accumulative back extrusion process at 330 °c.  the obtained microstructures were studied using optical and...