A cyclic wet/dry accelerated corrosion test was used to compare the corrosion behavior of medium-Mn steel and Q345 steel. In terms of scanning electron microscope (SEM), using X-ray diffraction (XRD), electron probe microanalysis (EPMA), X-ray photoelectron spectroscopy (XPS), and analysis of the corrosion process, the results showed that the medium-Mn steel did not exhibit higher corrosion res...

t is known that the protective value of zinc is partially a result of its ability to form a protective film when plated on a base metal, such as steel. The zinc is sacrificial and corrodes I preferentially to protectthe steel. Although pure zinc coating provides some degree of protection for the substrate, in a severe corrosion environment, zinc is consumed rapidly. For this reason, it is usual...

Metal cutting is a severe plastic deformation process involving large strains, high strain rates, and high temperatures. Conventional analysis of the chip formation process is based on bulk material deformation disregarding the inhomogeneous nature of the material microstructure. A series of orthogonal cutting tests of AISI 1045 and 1144 steel were conducted which yielded similar process charac...

The noble shift in open-circuit potential exhibited by microbially colonized stainless steel (ennoblement) was investigated by examining the relationship among surface colonization, manganese deposition, and open-circuit potential for stainless steel coupons exposed to batch cultures of the manganese-depositing bacterium Leptothrix discophora. Open-circuit potential shifted from -100 to +330 mV...

protective coatings that resist oxide scale growth and decrease chromium evaporation are necessary to makestainless steel interconnect materials for long-term durable operation of solid oxide fuel cells (sofcs). inthis study a layer of manganese was coated on the surface of aisi 441 ferritic stainless steel which is used insolid oxide fuel cells for interconnect applications. the oxidation beha...

low carbon steel samples were both shot into and inoculated with titanium in order to improve mechanical properties such as strength and toughness. sem observations and x-ray analyses revealed that titanium nitride and titanium carbonitride precipitates being scattered in the ferrite substrate reduce the grain size in all as-cast, heat-treated and as-rolled cases. the growth of the grains at hi...

The wear failure mode of a paver spiral blade was simulated by EDEM software. High-manganese steel, medium chromium alloy and high steel were selected as matrix materials; SiC particles WC surface particle reinforcement the prepared EPC process. performance mechanism analyzed microstructure, hardness, impact, pin disk, erosion test, morphology. Modeling with software applying discrete element a...

High-manganese Hadfield cast steel is commonly used for machine components operating under dynamic load conditions. The high fracture toughness and abrasive wear resistance of this are the result an austenitic structure, which—while being ductile—at same time tends to surface harden effect cold work. Absence loads (e.g., in case sand abrasion) causes rapid premature parts. To improve high-manga...

with careful design, mixed microstructures consisting of fine plates of upper bainitic ferrite separated by thinfilms of stable retained austenite have exhibited impressive combinations of strength and toughness in highsiliconbainitic steels. the silicon suppresses the precipitation of brittle cementite leading to an improvement intoughness. the essential principles governing the optimisation o...