نتایج جستجو برای: hydro power turbine

تعداد نتایج: 512746  

2015
Weijia Yang Jiandong Yang Wencheng Guo Wei Zeng Chao Wang Linn Saarinen

This paper presents a mathematical model of hydro power units, especially the governor system model for different operating conditions, based on the basic version of the software TOPSYS. The mathematical model consists of eight turbine equations, one generator equation, and one governor equation, which are solved for ten unknown variables. The generator and governor equations, which are differe...

Journal: :International Journal of Research in Engineering and Technology 2015

2017
Linhai Liu Baoshan Zhu Li Bai Xiaobing Liu Yue Zhao

Pumped hydro energy storage (PHES) is currently the only proven large-scale energy storage technology. Frequent changes between pump and turbine operations pose significant challenges in the design of a pump-turbine runner with high efficiency and stability, especially for ultrahigh-head reversible pump-turbine runners. In the present paper, a multiobjective optimization design system is used t...

Journal: :Energy Science & Engineering 2021

This paper investigates the critical stable sectional area (CSSA) of downstream surge tank (DST) hydropower plant with sloping ceiling tailrace tunnel (SCTT). Firstly, two types nonlinear mathematical model SCTT during transient process are established. Then, criterion operation stability is obtained based on theory. Formulae for CSSAs DST under derived. Finally, similarities, differences, and ...

2013
J. Godson M. Karthick T. Muthukrishnan M. S. Sivagamasundari

Renewable energy sources i.e.,energy generated from solar, wind, biomass, hydro power, geothermal and ocean resources are considered as a technological option for generating clean energy. But the energy generated from solar and wind is much less than the production by fossil fuels, however, electricity generation by utilizing PV cells and wind turbine increased rapidly in recent years. This pap...

Journal: :energy equipment and systems 2015
saadat zirak hamid ebrahimi ahmad reza maissamy

determination of the starter torque-speed diagram is a major task in the design or selection of a proper gas turbine starter. in this paper, the maximum power of the mgt-40 gas turbine starter was calculated based on the dynamics of the rotor, start-up logic, and compressor map. in a recent research, the pressure ratio was assumed as a linear function of the rotor speed and the required starter...

Journal: :journal of artificial intelligence in electrical engineering 2015
davoud karimzadeh

due to increasing expansion of energy consumption and also the decrease and tendency towardsending fossil energy reserves, the current energy cycle needs to use alternative energy speciallywind energy, because it’s considerably cheaper than other recycling sources. the presentresearch investigates suitable possibility of exploiting wind energy to create wind power stationin soltanieh zone of za...

2011
Muldi Yuhendri Mochamad Ashari Mauridhi Hery Purnomo

The Output power of wind turbine is determined by wind speed. The Output power can be adjusted by controlling the generator speed and pitch angle of wind turbine. When the wind speed below the wind turbine rated, the output power of generator can be maximized by controlling the generator speed at point of maximum power coefficient. When the wind speed above the wind turbine rated, output power ...

Journal: :journal of electrical and computer engineering innovations 2014
mohammadreza hojatydana mohammadreza alizadehpahlavani

renewable energy sources like wind, sun, and hydro are considered as a reliable alternative to the traditional energy sources such as oil, natural gas, or coal. this paper describes modeling and simulations to determine a method for the power performance evaluation of autonomous wind turbine system. a speed control regulator is utilized to control the dc bus voltage. the inverter gate’s signals...

2001
Ken Maynard Martin Trethewey

The primary goal of the this paper is to summarize field demonstrations of the feasibility of detecting changes in blade and shaft natural frequencies (such as those associated with a blade or shaft crack) on operating machinery using non-contact, nonintrusive measurement methods. Laboratory demonstration of feasibility and some special signal processing issues were addressed in Parts 1 and 2 [...

نمودار تعداد نتایج جستجو در هر سال

با کلیک روی نمودار نتایج را به سال انتشار فیلتر کنید