I:U+ Abstract Length-sorted lumber is surfaced on one side t() 1.75-inch thickness, mechanically stacked 5 feet wide and 10 feet high on 1-1/4-inch-thick sticks, and continuously transported through a zone-controlled tunnel kiln at 8 ft./hr. t() yield 500,000 tbm of lumber dried t() 9 percent average MC per 168hour week. In the tunnel, the lumber is dried for 8 (possibly 10) hours at 270°F, con...

Performance of a gas turbine is mainly depends on the inlet air temperature. The power output of a gas turbine depends on the mass flow rate of air. Now days the atmosphere temperature is hot, so the air is less density, the mass flow rate will reduce and automatically the power output will reduce. A reduce of 1°C temperature of inlet air increases the power output by approximately 0.7MW. To re...

Purpose: The purpose of this study was to investigate the effects of two air-abrasive prophylaxis systems and the effect of inlet air pressure on the surface of Brhnemark titanium abutment cylinders. Materials and Methods: Single abutment cylinders were treated with either the Prophy-Jet system (sodium bicarbonate abrasive) (Dentsply International, York, PA) or the Microprophy system (aluminum ...

The temperature of exhaust gases from simple cycle gas turbine generation sets (GENSETs) is usually very high (around 500 C), and a heat recovery steam generator (HRSG) is often used to recover the energy from the exhaust gases and generate steam. The generated steams can be either used for many useful processes (heating, drying, separation etc.) or used back in the power generation system for ...

Reduction of data centre power consumption is a timely challenge. Waste heat reuse is another focus area when developing energy efficient and sustainable data centres. And these two issues are interconnected through liquid cooling of server racks and/or direct-to-chip liquid cooling. Both of these solutions make it possible to transfer a significant proportion of the waste heat energy back to p...

In this study, artificial neural networks have been used to model the effects of four important parameters consist of the ratio of the length to diameter, the ratio of the cold outlet diameter to the tube diameter, inlet pressure, and cold mass fraction on the cooling performance of counter flow vortex tube. In this approach, experimental data have been used to train and validate the neural net...

To get comfortable air, it can be done by using an air conditioner or cooler. The electrical power used for the cooler is relatively lower. This research aims to see effect of number cooling pads on output condition and effectiveness was conducted experimentally. varying used, thick. distance between 1.5 cm. temperature inlet has a dry bulb 30

This paper presents a universal engineering model, which can be used to formulate both counterflow and crossflow cooling towers. By using fundamental laws of mass and energy balance, the effectiveness of heat exchange is approximated by a second order polynomial equation. Gauss-Newton and Levenberg-Marquardt methods are then used to determine the coefficients from manufactures data. Compared wi...