Superconducting thin films have the potential to improve the performance of particle accelerators. Before these thin films can be implemented, a systematic study on structureproperty correlations is necessary. Here, we present the characterization of niobium thin films deposited onto both ceramic and metallic substrates. In particular, the film microstructure and superconducting properties are ...

This work presents a new synthesis of nano-sized lithium niobate particles by a low temperature three steps procedure. The complete protocol implies a LiH induced reduction of NbCl5 followed by in situ spontaneous oxidation into low valence niobium nano-oxides. These niobium oxides are exposed to air atmosphere leading to pure Nb2O5 formation. Finally, the stable Nb2O5 is converted into lithium...

A calorimetric technique enables precise measurements of the surface resistance RS of superconducting samples. One of the devices exploiting this technique at multiple frequencies is the Quadrupole Resonator. Its measurement capabilities and limitations are discussed and compared with similar devices. Results on bulk niobium and niobium film on copper samples are presented. It is shown how diff...

High-resolution conductance measurements in niobium nanowires below the superconducting transition temperature are presented. Results are shown for a complete multistage elongation-compression cycle of a nanoscale contact. We focus on a bistability region which manifests itself as random telegraph noise. Density functional structural optimizations and conductance calculations using the non-equi...

We characterize inductors fabricated from ultra-thin, approximately 100 nm wide strips of niobium (Nb) and niobium nitride (NbN). These nanowires have a large kinetic inductance in the superconducting state. The kinetic inductance scales linearly with the nanowire length, with a typical value of 1 nH µm(-1) for NbN and 44 pH µm(-1) for Nb at a temperature of 2.5 K. We measure the temperature an...

The proposed linear electron-positron collider TESLA is based on 1.3 GHz superconducting niobium cavities for particle acceleration. For a center-of-mass energy of 500 GeV an accelerating field of 23.4 MV/m is required which is reliably achieved with a niobium surface preparation by chemical etching. An upgrade of the collider to 800 GeV requires an improved cavity preparation technique. In thi...

In an attempt to correlate the performance of superconducting radiofrequency cavities made of niobium with the superconducting properties, we present the results of the magnetization and ac susceptibility of the niobium used in the superconducting radiofrequency cavity fabrication. The samples were subjected to buffer chemical polishing (BCP) surface and high temperature heat treatments, typica...

Field emission and thermal breakdown are the main mechanisms limiting the accelerating gradient of niobium radio-frequency cavities. Diagnostic tools to study these mechanisms include quality measurements, thermometry, and microscopy. Results presented here demonstrate that micron-size, conducting particles are the source of field emission. Thermal breakdown is caused by a variety of defects su...

The influence of various preparation methods on the performance of V-Nb-0 catalysts has been investigated. It was found that the activity and selectivity of a vanadium site depend on the nature of the neighbouring atoms. Vanadium neighbours provide activity, while niobium neighbours provide selectivity. Careful preparation of these catalysts ensures a homogeneous distribution and good mixing of...

We report small-angle neutron-scattering (SANS) measurements of flux line properties near H(c2) in an ultrapure sample of niobium with weak pinning of flux in the bulk. These confirm in detail the Abrikosov picture of the flux line lattice to within 20 mK of the upper critical field line. However, it has recently been claimed [X. S. Ling et al., Phys. Rev. Lett. 86, 712 (2001)], on the basis of...