Indentation-induced plastic deformation of amorphous silicon (a-Si) thin films was studied by in situ Raman imaging of the deformed contact region of an indented sample, employing a Raman spectroscopy-enhanced instrumented indentation technique. Quantitative analyses of the generated in situ Raman maps provide unique, new insight into the phase behavior of as-implanted a-Si. In particular, the ...

The glabrous skin of the monkey's hand was stimulated with a waveform that indented the skin at a rate of 0.4 mm/sec, held the skin steadily or nearly steadily indented for 12 sec or longer, and then retracted back to the starting position. Recordings were made of activity in single afferent fibers in response to these stimuli. The average discharge frequency of 21 slowly adapting mechanorecept...

Mechanical properties of ZnS nanobelts were measured at room temperature by direct nanoindentation experiments. It was found that the ZnS nanobelts achieve 79% increase in hardness but 52% decrease in elastic modulus compared to bulk ZnS. The nanobelts were found to exhibit creep under indentation. Indentation cracking was preferred along the belt growth direction. Indentation deformation behav...

Multiple length-scale effects are demonstrated in indentation-strength measurements of a range of ceramic materials under inert and reactive conditions. Meso-scale effects associated with flaw disruption by lateral cracking at large indentation loads are shown to increase strengths above the ideal indentation response. Micro-scale effects associated with toughening by microstructural restraints...

Molecular dynamics simulations are used to examine the nanometer-scale indentation of a thin film of amorphous carbon with a nonrigid sp bonded carbon tip. The simulations show in detail the atomic-scale mechanism of the indentation process and compare the bonding character of the film before and after indentation. The computationally determined elastic modulus of the amorphous-carbon film is f...

Introduction Currently, the load-bearing capacity of tissueengineered cartilage is insufficient. Inducing sufficient collagen content with an arcade-like architecture is a solution. Recently, sliding indentation was proposed for this puropse. However, it was only initially explored and further optimization may yield significantly better results. The aim of this study is to investigate in-silico...

One-to-one comparisons between indentation experiments and atomistic modelling have until recently been hampered by the discrepancy in length scales of the two approaches. Here, we review progress in atomic-scale nanoindentation experiments employing scanning probe techniques to achieve depth-sensing indentation and field ion microscopy to permit detailed indenter characterization. This perspec...

All impact analyses performed so far for the composite plates, have treated central impacts. Furthermore, investigations on influences of the in-plane biaxial compression, tension, or tension-compression preloads on various responses of the low-velocity impact, especially the indentation, have not been performed so far. In the present research, a finite element formulation is presented for resp...

Theoretical analysis and finite element (FE) simulation have been carried out for a constant specific load rate (CSLR) indentation creep test. Analytical results indicate that both the representative stress and the indentation strain rate become constant after a transient period. Moreover, the FE simulation reveals that both the contours of equivalent stress and equivalent plastic strain rate u...

The application of incremental processes in the manufacturing industry is having a great development in recent years. The first stage of an Incremental Forming Process can be defined as an indentation. Because of this, the indentation process is starting to be widely studied, not only as a hardening test but also as a forming process. Thus, in this work, an analysis of the indentation process u...