the mechanical behaviour of rockfill materials and aggregates depends not only on particle size and compaction, but also on their strength and lithological properties. in this research two types of large triaxial and direct shear tests are performed on rockfill materials. this paper compares the stress-strain behaviour of sandstone and andesibasalt materials in triaxial compression tests (3006...

This paper reports on an experimental and analytical investigation conducted into efficacy of the scraping shear-test method in estimating the shearing adhesive strength of a thermally sprayed coating. It was found that the critical average shear stress, the apparent failure strength of WC-Co thermal spray coating, depends on both the dimensions of the test piece and the loading position around...

the effects of cementation and the physical properties of grains on the shear behavior of grouted sands are investigated in this paper. the consolidated-undrained triaxial shear behavior of three grouted carbonate sands with different physical properties, including particle size distribution, particle shape and void ratio, was studied. two sands were obtained from the north shores of the persia...

series of undrained monotonic triaxial tests and cone penetration tests were conducted on loose silty sand samples to study correlation between undrained shear strength of silty sands (sus) and piezocone test results. cpt tests were conducted at 27 silty sand samples in calibration chamber. the results indicate that, in low percent of silt (0-30%), as the silt content increases, the undrained s...

Tests of deep concrete beams with internal fiber-reinforced polymer (FRP) reinforcement have shown that such members can exhibit lower shear strength than members with conventional steel reinforcement. To model this effect, the current paper proposes an approach based on a two-parameter kinematic theory (2PKT) for conventional deep beams. The 2PKT is built on a kinematic model with two degrees ...

STATEMENT OF THE PROBLEM Porcelain laminate veneer is an esthetic restoration used as an alternative to full veneer crowns and requires minimal tooth preparation. In restoration with porcelain laminate veneers, both the longevity of the laminate and conservation of the sound tooth structure are imperative. PURPOSE The present study aimed to investigate the shear bond strength of porcelain lam...

The addition of steel fibers into concrete improves the postcracking tensile strength of hardened concrete and hence significantly enhances the shear strength of reinforced concrete reinforced concrete beams. However, developing an accurate model for predicting the shear strength of steel fiber reinforced concrete (SFRC) beams is a challenging task as there are several parameters such as the co...

introdouction: esthetic demands of patients have led to the introduction of tooth-colored restorations wherecomposite resins are bonded to the enamel using acid etch techniques. total etch adhesion systems are still considered as the gold standard among bonding systems. however, clinicians have a tendency to use adhesive systems with simpler application procedures. the aim of the present study ...

In this research in-plane shear Behavior of composite steel-concrete shear walls was investigated considering the Effects of steel plates thickness, spaces between shear studs, shape and type of shear studs and existing of minimum reinforcement in wall section. Several finite element models were analyzed and Numerical results of two models were taken under verification with existent experimenta...