BACKGROUND According to the UK Adult Dental Health Survey (2009) 15% of adults aged 65-74, 30% aged 75-84 and 47% aged >85 years are edentulous and require complete dentures. Patients' quality of life and nutrition status are affected by poor dentures. The quality of the dental impression is the most important issue for improving the fit and comfort of new dentures. There is paucity of RCT evid...

PURPOSE The purpose of this study was to compare the fit of cast gold crowns fabricated from the conventional and the digital impression technique. MATERIALS AND METHODS Artificial tooth in a master model and abutment teeth in ten patients were restored with cast gold crowns fabricated from the digital and the conventional impression technique. The forty silicone replicas were cut in three se...

abstract       background and aim: dimensional changes of the impression materials after disinfection is a serious problem in dentistry which could fail the treatment. the aim of this study is to determine the effect of three disinfectants:2% deconex,5.25% sodium hypochlorite and nanosil d2 ,on dimensional changes of bayer alginate.       materials and methods: this experimental study was condu...

Creep compliance measurements were shown to be effective in characterizing the elastic, retarded elastic, and viscous properties of polysulphide, silicone, and polyether impression materials. The test is particularly valuable in that the creep compliance was independent of load, allowing the mechanical properties to be represented by a single total creep compliance curve which can be used to de...

Agar has been used for a number of years in the preparation of elastic duplicating materials. These duplicating materials have been used mainly in partial denture prosthesis for the preparation of a duplicate refectory cast of the original stone cast of the patient's mouth. Since moderately large quantities of duplicating materials are used in these procedures, the low cost and reversibility of...

PURPOSE The objective was to evaluate canine positions, intercanine tip width (ICTW) and width of distal surface of canine (WDC), related to facial landmarks including interalar width (IAW), intercommissural width (ICoW), and distance between left and right projection lines drawn from inner canthus of eyes to alae of the nose (DPICa) in a group of Thai. MATERIALS AND METHODS One hundred Thai ...

In this paper, the multiscale analysis of reproduction accuracy jaw geometry obtained via use selected orthodontic materials is discussed. Impressions were made from two types impression material. An assessment model mapping was performed using noncontact systems, including a fringe projection optical 3D scanner, computed tomography, and focus variation microscope. Measurements in three modes f...

OBJECTIVES The aim of the present study was to compare the fit of all-ceramic crowns fabricated from intraoral digital impressions with the fit of all-ceramic crowns fabricated from silicone impressions. METHODS Twenty patients agreed to take part in the study to receive two Lava crowns each for the same preparation. One crown was fabricated from intraoral scans using the Lava Chairside Oral ...

An impression technique called optical impression using intraoral scanner has attracted attention in digital dentistry. This study aimed to evaluate the accuracy of the optical impression, comparing a virtual model reproduced by an intraoral scanner to a working cast made by conventional silicone impression technique. Two implants were placed on a master model. Working casts made of plaster wer...