The present work evaluates the performance of solar collector using Al2O3-C2H6O2-H2O nanofluid as a working fluid through both experimental and CFD analysis. Ethylene-glycol water mixture (40:60 v/v) is used as base fluid, where α-Al2O3 nanoparticle of 20 nm average size is dispersed for the preparation of nanofluid of four different volumetric concentration (vol. conc.) of 0.05, 0.075, 0.1 and...

A TRNSYS component (Type 262) has been written to simulate a concentrating PV/Thermal collector. The component is based on a dynamic model of a concentrating PV/Thermal collector, which includes thermal capacitance effects, and detailed equations describing the temperature dependent energy flow between the collector and surroundings. The CHAPS system, a 30x concentration parabolic trough PV/The...

The performance of the Combined Heat and Power Solar (CHAPS) collectors at the Australian National University is described. Results from testing of the collector under steady state conditions at a range of input temperatures are presented. Measured results under typical operating conditions show thermal efficiency around 57% and electrical efficiency around 11%, and therefore a combined efficie...

This study examines modeling and simulation of the transient thermal behavior of a solar collector adsorber tube. The data used for model setup and validation were taken experimentally during the start-up procedure of a solar collector adsorber tube. ANN models are developed based on the nonlinear autoregressive with exogenous input NARX model and are implemented using the MATLAB® tools includi...

Solar desiccant cooling is widely considered as an attractive replacement for conventional vapor compression air conditioning systems because of its environmental friendliness and energy efficiency advantages. The system performance of solar desiccant cooling strongly depends on the input parameters associated with the system components, such as the solar collector, storage tank and backup heat...

many researchers have investigated how to increase the overall efficiency of solar-driven thermal systems. several key parameters, such as collector efficiency and storage tank characteristics, may impose some constraints on the annual solar fraction (asf) of such systems. in this paper, the behaviour of integrating the phase change material (pcm) in sdhw systems is modelled and optimized numer...

Solar-heated air can be used in a wide variety of applications, but it is a limited resource. Only so much sunshine strikes each square foot of the earth, and a well-built collector system will typically deliver about half of this energy to a house in the form of heat. The way this heat is used often means the difference between a useful, cost-effective system and one that never seems to perfor...

Recently Debates about Energy and the issue of global warming have led to the use of new energy. One of the best options for this purpose is the use of a new hybrid system of power, heating and refrigeration, with its thermal source of solar and geothermal energy. In the present study, used a combined cooling, heating and power system based on the organic Rankine cycle and the Ejector Refrigera...

The overall heat loss coefficient (U-value) of a vacuum tube solar collector is investigated experimentally and theoretically with regard to the pressure of the remaining gas inside the evacuated glass envelope. A number of collector tubes of same geometry are randomly selected from an installation of a solar based air-conditioning system and tested individually in the laboratory for the determ...

In this paper, on the basis of Green Comprehensive Plan at Hakim Sabzevari University of Sabzevar, Iran, the application of active solar  systems for the dining hall is evaluated. The impact of solar systems and energy management designed for this hall on energy consumption and environment was investigated.This study measures the electricity and thermal energy consumption of the dining hall , p...