This paper presents the multiple response optimization of end milling parameter using grey based taguchi method. Experiments were designed and conducted based on L27 orthogonal array design The milling parameter were spindle speed, depth of cut, feed rate and pressurized coolant jet and the response was surface roughness. EN31, high carbon alloy steel which achieves a high degree of hardness an...

The effects of cutting tool coating material and cutting speed on cutting forces and surface roughness were investigated by Taguchi experimental design. Main cutting force, Fz is considered as a criterion. The effects of machining parameters were investigated using Taguchi L18 orthogonal array. Optimal cutting conditions were determined using the signal-to-noise (S/N) ratio which is calculated ...

This paper describes an optimum cutting parameters for Titanium Grade5 (Ti-6Al-4V) using Wire-cut Electrical Machining Process (WEDM). The response of Volume Material Removal Rate (MRR) and Surface Roughness (Ra) are considered for improving the machining efficiency. A brass wire of 0.25mm diameter was applied as tool electrode to cut the specimen. The Experimentation has been done by using Tag...

This paper presents the optimization of high speed milling process parameters with respect to the surface roughness of samples and the study of the Taguchi design application to surface quality in a CNC end milling operation. The Taguchi design is an efficient and effective experimental method in which a response variable can be optimized given various control factors using fewer resources than...

This paper presents the optimization of CNC turning parameters for EN 16 steel bar using the Grey Taguchi Method. A plan of experiments based on Taguchi’s L27 orthogonal array was established and turning experiments were conducted with prefixed cutting parameters for EN 16 steel bar using tungsten carbide tool. The turning parameters are cutting speed, feed rate and depth of cut and the respons...

(Received: Feb. 24, 2013; Accepted in Revised Form: April 9, 2013) Abstract: Mycophenolic acid (MPA) is an antibiotic and immunosuppressive agent, as a secondary metabolite of Penicillium brevicompactum. Parameter optimization of culture composition using Test plan L16, available in the form of an orthogonal array and software for automatic design and analysis of the experiments, both based on ...

In machining to improve machinability, productivity and to extend tool life coolants and lubricants where used .Increasing industry the use of cutting fluids subsequently increasing this leads in reduce of living conditions nearby future all the governments recommend the manufacturers to reduce the usage of toxicity cutting fluids. Still research for dry machining challenge is exiting for the i...

This paper focused on evaluation of machining parameters influencing thrust force during drilling of Al–SiC–Gr metal matrix composites using multifaceted carbide drills. There are three machining parameters i.e. Spindle speed, Feed rate, Drill diameter. Experiments are conducted on a vertical machining centre using Taguchi design of experiments. Taguchi orthogonal array is designed with three l...

A three-level six-factor (arc power, substrate temperature, pre-treatment bias voltage, working pressure, deposition bias voltage and pretreatment time) orthogonal experimental array (L18) to optimize the adhesion strength of arc ion plating (AIP) TiAlN films was designed using the Taguchi method. An optimized film process, namely substrate temperature 220 °C, arc power 60 A, negative bias volt...