Effective thermal conductivity of mixtures of  uids and nanometer-size particles is measured by a steady-state parallel-plate method. The tested  uids contain two types of nanoparticles, Al2O3 and CuO, dispersed in water, vacuum pump  uid, engine oil, and ethylene glycol. Experimental results show that the thermal conductivities of nanoparticle– uid mixtures are higher than those of the bas...

Polymer composites with high thermal conductivity have recently attracted much attention, along with the rapid development of the electronic devices toward higher speed and performance. However, a common method to enhance polymer thermal conductivity through an addition of high thermally conductive fillers usually cannot provide an expected value, especially for composites requiring electrical ...

The preparation of nanofluids is very important to their thermophysical properties. Nanofluids with the same nanoparticles and base fluids can behave differently due to different nanofluid preparation methods. The agglomerate sizes in nanofluids can significantly impact the thermal conductivity and viscosity of nanofluids and lead to a different heat transfer performance. Ultrasonication is a c...

We show that certain three-dimensional (3D) superlattice nanostructure based on Bi2Te3 topological insulator thin films has better thermoelectric performance than two-dimensional (2D) thin films. The 3D superlattice shows a predicted peak value of ZT of approximately 6 for gapped surface states at room temperature and retains a high figure of merit ZT of approximately 2.5 for gapless surface st...

Thermal conduction modes in a nanocolloid (nanofluid) are quantitatively assessed by combining linear response theory with molecular dynamics simulations. The microscopic heat flux is decomposed into three additive fluctuation modes, namely, kinetic, potential, and collision. For low volume fractions (<1%) of nanosized platinum clusters which interact strongly with xenon host liquid, a signific...

The thermal conductivity of superconducting MgB 2 was studied in both the superconducting and normal state region. The latter is almost equally determined by the electronic-and the lattice thermal conductivity. In the superconducting state, however, the lattice thermal conductivity is larger. The electronic thermal conductivity below T c was derived from the experimental data considering the Ba...

The conversion into nanofluids is considered a suitable solution to increase the heat transfer efficiency of such fluids. Several theories with an emphasis on different thermal nanofluid mechanisms have appeared to predict enhanced conductivity measurements. There are many ways to measure the thermal conductivity of fluids. Some researchers argued that the anomalous k enhancement data are cause...